Scribd
Upload
64 views

Anna University of Technology-Coimbatore

This document contains the question paper for the Networks Laboratory examination at Anna University of Technology-Coimbatore for the third year, fifth semester Electronics and Communication Engineering students on October 18, 2011. It lists 13 questions related to designing and implementing various computer networking concepts through simulation, including error detection methods, subnetting, local area networks, carrier sensing, token passing, routing algorithms, encryption, and error control protocols. The internal and external examiners are listed at the bottom.

Uploaded by

Satheesh Kumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
64 views

Anna University of Technology-Coimbatore

This document contains the question paper for the Networks Laboratory examination at Anna University of Technology-Coimbatore for the third year, fifth semester Electronics and Communication Engineering students on October 18, 2011. It lists 13 questions related to designing and implementing various computer networking concepts through simulation, including error detection methods, subnetting, local area networks, carrier sensing, token passing, routing algorithms, encryption, and error control protocols. The internal and external examiners are listed at the bottom.

Uploaded by

Satheesh Kumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 3

ANNA UNIVERSITY OF TECHNOLOGY-COIMBATORE

UNIVERSITY PRACTICAL EXAMINATIONS-OCTOBER 2011


NETWORKS LABORATORY
(ELECTRONICS & COMMUNICATION ENGINEERING)
QUESTION PAPER
College code & Name

: 603-Excel Engineering College

Course code

: 080290035

Year/Semester

: III / V

Date

: 18/10/2011

1.

Design and Implement highly accurate error detection method based on


interpreting a pattern of bits as a polynomial.
2. Find the sub network address for the following using Simulation
IP address

Mask

140.11.36.22

255.255.250.0

3. Design and implement a Local Area Network which allows resources to be shared
between personal computers.
4. Design a Carrier sensing mechanism to determine if the medium is busy or idle.
5. Design and Implement a LAN using ring topology and token passing access
method.
6. Design and Implement a Physical Bus using token passing access method
simulation.
7. Design and Implement Standard IEEE 802.11 through simulation.
8. Design an Error control method in which the frame in error and all following
frames must be retransmitted.
9. Design and Implement a Protocol in which the sender sends one frame, stops
until it receives confirmation from the receiver, and then sends the next frame.
10. Design a Routing algorithm in which each router sends its neighbors a list of
networks it can reach and the distance to that network.
11. Design a Routing algorithm in which each router shares its knowledge of changes
in its neighborhood with all other routers.
12. Implement an algorithm that converts a message into an unintelligible form unless
decrypted.
13. Design and Implement an error control method in which only the frame in error is
resent.
INTERNAL EXAMINER

EXTERNAL EXAMINER

Question:1. Design and Implement Selective Retransmission Protocol through


simulation.
2. Implement an algorithm that converts Plain text into unintelligent form and
reconverts into Plain text
Question:1. Design and Implement a LAN using ring topology and token passing access
method.
2. Design and Implement Link state algorithm through simulation.
Question:1. Design and Implement Distance vector algorithm through simulation.
2. Implement the Stop and wait protocol through simulation.
Question:1. Design and Implement Go-Back-N Protocol through simulation.
2. Design and Implement a Physical Bus using token passing access method
simulation.
Question:1. Design and Implement IP Subnet through simulation using Examples.
2. Design and Implement CSMA/CA Protocol (IEEE802.11) through
simulation.
Question:1. Design and Implement IP Subnet through simulation using Examples.
2. Design and Implement Go-Back-N Protocol through simulation.
Question:1. Design and Implement a LAN using ring topology and token passing access
method.
2. Implement the Stop and wait protocol through simulation.
Question:1. Design and Implement CSMA/CA Protocol (IEEE802.11) through
simulation.

2. Design and
simulation.

Implement

Selective

Retransmission

Protocol

through

Question:1. Design and Implement Distance vector algorithm through simulation.


2. Design and
simulation.

Implement

Selective

Retransmission

Protocol

through

Question:1. Design and Implement Link State algorithm through simulation.


2. Implement an algorithm that converts Plain text into unintelligent form and
reconverts into Plain text

You might also like