Scribd
Upload
57 views

1、 Driver installation

This document provides instructions for installing drivers, software, and using the software for a multimeter device connected to a computer. It describes running executables as an administrator to install the drivers found on the included CD-ROM. It then explains opening the software, connecting the multimeter, and how the software will automatically detect and record from the connected device or allow manual selection of the correct serial port.

Uploaded by

George Chirica
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
57 views

1、 Driver installation

This document provides instructions for installing drivers, software, and using the software for a multimeter device connected to a computer. It describes running executables as an administrator to install the drivers found on the included CD-ROM. It then explains opening the software, connecting the multimeter, and how the software will automatically detect and record from the connected device or allow manual selection of the correct serial port.

Uploaded by

George Chirica
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 8

1 Driver installation

1. After connecting the device to the computer for the first time, your
computer may prompt you to install drivers for this device (After you
have installed the drivers, it will not ask again when connecting).
Open the CD-ROM, navigate to the Drivers folder, right click on either
CP210xVCPInstaller_x64.exe

(64bit

operating

systems)

or

CP210xVCPInstaller_x86.exe (32 bit operating systems) and select Run


as administrator.

2. Select Next in the pop-up dialog box.

3. Select I accept this agreement and click Next.

4. Please wait for the drivers install.

5. Click Finish to complete the installation.

2 Software installation
1Open the CD-ROM, navigate to the Software folder, right click on
Setup.exe and select Run as administrator.

2Select a language and click OK.

3. Click Next.

4You can either install to the default destination folder or select another
folder by clicking Browse. After the folder is set, click Install.

5Please wait while software is installed.

6Click Finish to complete the installation.

3 Software manuals
1 Connect the multimeter to the computer and switch the meter to the
function you want to record. Open the multimeter software on the
computer and the software will try to detect the connected multimeter.

2 When the software detects the connected multimeter, it will begin


recording automatically.

3 If the software does not detect the connected multimeter, or the multimeter
is disconnected, the software will indicate the meter is offline.

4 If necessary, you can select the serial port manually.

Turn on the

multimeter, connect it to the computer and click Option>Setting. Choose


the corresponding serial port and sampling frequency in the pop-up dialog
box and click OK to complete the setup.

5 Click Run>Start and the software will start recording.


6 The software can record up to 50,000 points of data. the software will stop
recording once it hits this limit.

You might also like