Scribd
Upload
14 views1 page

Form 7211 Gasket Specs Hee Trev 32916

The document is a gasket specification form used by Advance Products & Systems, Inc. to manufacture gaskets correctly. It requests information about the type of connection, material, dimensions, and other details needed to produce the required gasket.

Uploaded by

harry
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
14 views1 page

Form 7211 Gasket Specs Hee Trev 32916

The document is a gasket specification form used by Advance Products & Systems, Inc. to manufacture gaskets correctly. It requests information about the type of connection, material, dimensions, and other details needed to produce the required gasket.

Uploaded by

harry
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Form. 7.2-1-1 Rev.

3/29/16

Advance Products & Systems, Inc.


P.O. Box 60399
Lafayette, LA 70596-0399
Phone: 337-233-6116 Fax: 337-232-3860
E-mail: [email protected]
Website: www.apsonline.com

Gasket Specification

Please fill out the appropriate sections of the following form in order for APS to manufacture your gasket correctly.
NOTE: If both Section A and B are completely filled out, only fill out the dimensions in section C which have an asterisk. If section B is not completed, then all
dimensions in section C need to be filled out.

SECTION A

Type of Connection Needed

Type of Gasket Needed

Flange Connection

_________

Type E
Full Face

Flange ID

_________

Type F
Raised Face

Valve ID

ANSI

AS

API

Seal:

Phenolic

Nitrile

Nitrile Coated Phenolic

Viton

G10

PTFE

Sleeve:

AWWA

Nominal Pressure Rating

Washer: Micarta

Micarta
Integral

G10

G10

Flange Standard

MSSP-44 DIN

Class

Gasket:

Other: ___________
EPDM
Note: Only G10 gasket material with EPDM or PTFE seals are NSF61 approved.

Valve Connection

SECTION B

Type of Material Needed Note: Check one type of material for


each item.

Steel

Mylar

JIS

BS

OTHER

Nominal Size

Stainless Steel

Other: _____________

Quantity of seals:

Other: ___________

Quantity of washers:
Single

Single

Duplex

Double

SECTION C Notes:

If flanges are not identical, you must specify both flange thicknesses for sleeve to fit properly; Standard Calculations: THK#1+THK#2+GASKET THK+0.0625 = standard
sleeve length. F Gasket O.D. is (BC-BH-1/16)

*ACTUAL GASKET I.D.

ID

(important for the gasket to seal properly)

FLANGE O.D
BOLT CIRCLE
BOLT HOLE QTY
Company Name:

OD
BC
H#

BOLT HOLE SIZE


BOLT SIZE
SHOULDER BOLT
DIAMETER (if used)
SLEEVE LENGTH
(if custom length needed)

Signature:

BH
BS
SHO
SL

Note: For raise face flanges please


add the raise face thickness to the
flange thickness when entering flange
thicknesses below
FLANGE#1
THK#1
THICKNESS
FLANGE#2
THK#2
THICKNESS
Date:

Disclaimer: This version may not be the most current revision. Please visit www.apsonline.com to verify that you are utilizing the most current revision.

You might also like