How to config DWG2000B/C/D as Termination with Elastix
Dinstar Technologies Co., Ltd.
Address: Floor 6, Guoxing Building, Changxing Road, Nanshan District, Shenzhen, China
518057
Telephone: +86 755 2645 6664
Fax:
Emails:
+86 755 2645 6659
[email protected],
[email protected]Website: www.dinstar.com
Dinstar Technologies Co., Ltd.
How to config DWG2000B/C/D as Termination with Elastix
Contents
1.
2.
3.
Overview ....................................................................................................................... 3
Configure Elastix ........................................................................................................... 3
2.1 Logon the Elastix ..................................................................................................... 3
2.2 Add SIP Trunk ......................................................................................................... 4
2.4 Outbund Routes ...................................................................................................... 5
Configure DWG ............................................................................................................. 5
3.1 Add an IP Trunk ....................................................................................................... 5
3.2 Allow IP to GSM Call ............................................................................................... 6
3.3 Config Tel to IP Routing ........................................................................................... 7
3.4 Service Parameter ................................................................................................... 7
3.5 SIP Parameter ......................................................................................................... 8
Dinstar Technologies Co., Ltd.
How to config DWG2000B/C/D as Termination with Elastix
1. Overview
Here is a typical application of DWG work as termination. The calls traffic
from different countries which distributed by Elastix server, and finally
terminate by DWG gateways.
2. Configure Elastix
You need to configure a SIP Trunk to connect with DWG, and the Inbound &
Outbound Routes.
2.1 Logon the Elastix
Input the IP of your Elastix. https://172.16.33.58/. The main interface is as
follow, click PBX, and start to configuration.
Dinstar Technologies Co., Ltd.
How to config DWG2000B/C/D as Termination with Elastix
2.2 Add SIP Trunk
Click the menu "Trunk" as follow, then click "Add SIP Trunk".
Following pic show you how to configurate the SIP Trunk.
Dinstar Technologies Co., Ltd.
How to config DWG2000B/C/D as Termination with Elastix
After you fill all configurations, Click Submit Changes, Then click "Apply
configuration changes here" to apply it.
2.4 Outbund Routes
Following pic show you how to configurate the Outbound Routes.
Thats means if the Called number prefix is 9, will pass to DWG.
3. Configure DWG
3.1 Add an IP Trunk
Add a IP Trunk to connect with Elastix, the IP field input Elastix IP 172.16.33.58, the
port field is SIP port of Elastix, the default is 5060.
Dinstar Technologies Co., Ltd.
How to config DWG2000B/C/D as Termination with Elastix
3.2 Allow IP to GSM Call
If you want to allow any prefix call number to call, you can fill any like follow, else you
can fill the prefix you want to allow.
Dinstar Technologies Co., Ltd.
How to config DWG2000B/C/D as Termination with Elastix
3.3 Config Tel to IP Routing
If the call form IP trunk Elastix, routing it to DWG GSM channel.
3.4 Service Parameter
Because current DWG unregistered at Elastix, you should tick the option, please check
the follow pic: Allow Call from IP to GSM without Registration
Dinstar Technologies Co., Ltd.
How to config DWG2000B/C/D as Termination with Elastix
3.5 SIP Parameter
DWG connect Elastix Via IP trunk, so tick the Is Register to NO.
Dinstar Technologies Co., Ltd.
