Scribd
Upload
1K views1 page

Summit Power Recruitment Test 27-05-2015 Question by Rony Parvej

This document contains a recruitment test question bank for the position of Assistant Engineer (Electrical) at Summit Power Limited (SPL) held on May 27, 2015. The question bank was compiled by Rony Parvej and contains 15 multiple choice questions related to electrical engineering topics like RLC circuits, transformers, induction motors, generator protection systems, and circuit breakers. It also provides information on Rony Parvej's Facebook pages for electrical engineering preparation and his email for contact.

Uploaded by

Engr. Shahidul Islam
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views1 page

Summit Power Recruitment Test 27-05-2015 Question by Rony Parvej

This document contains a recruitment test question bank for the position of Assistant Engineer (Electrical) at Summit Power Limited (SPL) held on May 27, 2015. The question bank was compiled by Rony Parvej and contains 15 multiple choice questions related to electrical engineering topics like RLC circuits, transformers, induction motors, generator protection systems, and circuit breakers. It also provides information on Rony Parvej's Facebook pages for electrical engineering preparation and his email for contact.

Uploaded by

Engr. Shahidul Islam
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Summit power plant - 2015

Rony Parvejs EEE Question Bank

Recruitment Test Question of Summit Power Limited (SPL)


Collected from:
Compiled by: Rony Parvej (IUT, EEE07)

Post: Assistant Engineer (Electrical)


Time: 2 hours
Exam Date: 27.05.2015

Full Marks: 100


Venue: Unknown

1. If in a series RLC circuit, VS = 220 V, f= 50 Hz, R=20, L=0.3 H, C=0.03 F, then find
(i) Z
(ii) I and
(iii) power factor.
2. If in a transformer, NP = 800, NS = 40, RP=, RS =, XP=, XS=, then find Z01 referred to primary.
3. Explain the principle of transformer and draw the equivalent circuit of transformer referred to primary.
4. What is armature reaction and synchronous reactance?
5. Write the conditions of parallel operation of alternators.
6. Draw positive, negative and zero sequence network of the following:

7. In a 4-pole, 50 Hz induction motor, find


(i) Magnetic field speed,
(iii) Rotor frequency if slip is 3%,

(ii) Rotor speed if slip is 1%,


(iv) Rotor frequency at standstill.

8. Draw the schematic diagram of differential protection of transformer.


9. Write a short note on distance protection relay.
10. What is (i) Arc voltage (ii) Restriking Voltage and (iii) Recovery voltage?
11. Discuss the operation of Terminal voltage control of an alternator using Automatic Voltage Regulator
(AVR) system.
12. What is the purpose of circuit breaker?
13. Write different types of generator protection system.
14. What precaution should be maintained to work in 33/11 KV Transformer generator transmission line?
15. Find out the current flowing through 10 resistance using thevenins theorem.

EEE Job Preparation Facebook Group


EEE ACADEMY by Rony Parvej
Rony Parvej II Facebook Profile (Only for EEE)
(
)
(
) -

https://web.facebook.com/groups/eeejp/
https://www.facebook.com/eeeAcademy/
https://web.facebook.com/rony.ejp
https://www.facebook.com/ronyiut
[email protected]

You might also like