0% found this document useful (0 votes)
33 views2 pages

Case Study 2

An engineer needs to design an air conditioning system for a single-storey office building located at 30°N latitude. The report needs to include the total heat load, sensible heat load, and latent heat load. Information provided includes building construction details, outdoor/indoor design conditions, occupancy, and lighting load.

Uploaded by

Fong Wei Jun
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
33 views2 pages

Case Study 2

An engineer needs to design an air conditioning system for a single-storey office building located at 30°N latitude. The report needs to include the total heat load, sensible heat load, and latent heat load. Information provided includes building construction details, outdoor/indoor design conditions, occupancy, and lighting load.

Uploaded by

Fong Wei Jun
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

You as an engineer in one of the engineering company need to design an air conditioning for a 4

m high single-storey office building located at 30o N latitude as shown in Figure 1. You need to
write a complete report with
i) total heat load,
ii) sensible heat loads and
iii) latent heat loads.

Figure 1
1
Plaster on inside wall : 1 4
Outside wall construction : 20 cm concrete block
: 10 cm brick veneer
Partition wall construction : 33 cm brick
Roof construction : 20 cm RCC slab with 4 cm asbestos cement board
Floor construction : 20 cm concrete
Densities, brick : 3000 kg/m3
Concrete : 2200 kg/m3
Plaster : 1996 kg/m3
Asbestos board : 720 kg/m3
Fenestration
1
(Weather stripped loose fit) : 2 m X 1 2 m glass, U = 5.9 Wm-2K-1
1
Doors : 1 2 m X 2 m wood panels, U = 0.63 Wm-2K-1
Outdoor design conditions : 43oC DBT, 27oC WBT
Indoor design conditions : 34oC DBT, 50 % RH
Daily range : 31oC to 43oC = 12oC
Occupancy : 100
Lights : 15,000 W fluorescent

Assumed bypass factor of cooling coil 0.15.

You might also like