Scribd
Upload
258 views

Quiz 1

This document contains a quiz on electronic circuits with 6 multiple choice questions testing concepts related to DC power supplies, operational amplifiers, and rectifiers. It provides the questions, answers, and a marking scheme. The questions test the student's ability to identify components in a DC power supply diagram, output voltages of regulators, operational amplifier configurations, ideal op-amp characteristics, rectifier waveforms, and calculating the output of a non-inverting op-amp circuit. The document contains the full quiz, answer key, and breakdown of marks for each question.

Uploaded by

nixsone357
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
258 views

Quiz 1

This document contains a quiz on electronic circuits with 6 multiple choice questions testing concepts related to DC power supplies, operational amplifiers, and rectifiers. It provides the questions, answers, and a marking scheme. The questions test the student's ability to identify components in a DC power supply diagram, output voltages of regulators, operational amplifier configurations, ideal op-amp characteristics, rectifier waveforms, and calculating the output of a non-inverting op-amp circuit. The document contains the full quiz, answer key, and breakdown of marks for each question.

Uploaded by

nixsone357
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 6

DEE 3043 ELECTRONIC CIRCUITS

QUIZ 1 (CLO 1 & CLO 2)


NAME :
REG. NO :
PROGRAMME :

Instruction : Answer all questions.

1) Identify the correct arrangement of DC Power Supply block diagram.


A. Transformer, Rectifier, Regulator, Filter, Voltage Divider
B. Transformer, Rectifier, Filter, Voltage Divider, Regulator
C. Rectifier, Transformer, Filter, Regulator, Voltage Divider
D. Transformer, Rectifier, Filter, Regulator, Voltage Divider

2) Identify the output voltage produced by the LM7905 regulator.


A. +5V
B. -5V
C. +12V
D. -12V

3) An op-amp input produces a 180 o voltage phase shift (from input to output) when used as
input signal. Choose the correct input of the op-amp.
A. Gain input
B. Non-inverting input
C. Differential input
D. Inverting input

4) The true ideal ideal characteristics of an operational amplifier is :


A. Voltage Gain -
B. Input Impedance - 0
C. Output Impedance -
D. Input Offset Voltage -

5) Sketch the input and output waveform for full-wave bridge rectifier.

6) Based on figure below:


V in +
V o

Ra Rf

a) Identify type of operational amplifier.


b) Calculate the output voltage for the circuit if the input voltage is 5V, R a = 1 k and
Rf = 5 k.

Prepared by : Verified by:

DEE 3043 ELECTRONIC CIRCUITS

QUIZ 1 (CLO 1 & CLO 2)


NAME :
REG. NO :
PROGRAMME :

Instruction : Answer all questions

1) Identify the correct arrangement of DC Power Supply block diagram.


A. Rectifier, Transformer, Filter, Regulator, Voltage Divider
B. Transformer, Rectifier, Filter, Regulator, Voltage Divider
C. Transformer, Rectifier, Regulator, Filter, Voltage Divider
D. Transformer, Rectifier, Filter, Voltage Divider, Regulator

2) Identify the output voltage produced by the LM7805 regulator.


A. +5V
B. -5V
C. +12V
D. -12V

3) An op-amp input produces a 0 o voltage phase shift (from input to output) when used as input
signal. Choose the correct input of the op-amp.
A. Gain input
B. Non-inverting input
C. Differential input
D. Inverting input

4) The true ideal ideal characteristics of an operational amplifier as below, except:


A. Voltage Gain -
B. Input Impedance -
C. Output Impedance - 0
D. Input Offset Voltage -

5) Sketch the input and output waveform for full-wave bridge rectifier.

6) Based on figure below:


V in +
V o

Ra Rf

a) Identify type of operational amplifier.


b) Calculate the output voltage for the circuit if the input voltage is 5V, R a=10k and
Rf=20k.

Prepared by : Verified by:

DEE 3043 ELECTRONIC CIRCUITS

QUIZ 1 (CLO 1 & CLO 2)

ANSWER SCHEME
Instruction : Answer all question

1) Identify the correct arrangement of DC Power Supply block diagram. [CLO1] [1m]
A. Transformer, Rectifier, Regulator, Filter, Voltage Divider
B. Transformer, Rectifier, Filter, Voltage Divider, Regulator
C. Rectifier, Transformer, Filter, Regulator, Voltage Divider
D. Transformer, Rectifier, Filter, Regulator, Voltage Divider

2) Identify the output voltage produced by the LM7905 regulator. [CLO1] [1m]
A. +5V
B. -5V
C. +12V
D. -12V

3) An op-amp input produces a 180 o voltage phase shift (from input to output) when used as
input signal. Choose the correct input of the op-amp. [CLO1] [1m]
A. Gain input
B. Non-inverting input
C. Differential input
D. Inverting input

4) The true ideal ideal characteristics of an operational amplifier is : [CLO1] [1m]


A. Voltage Gain - 0
B. Input Impedance - 0
C. Output Impedance -
D. Input Offset Voltage -

5) Sketch the input and output waveform for full-wave bridge rectifier. [CLO1]

Input waveform [1.5m] Output waveform [1.5m]

6) Based on figure below:


V in +
V o

Ra Rf

a) Identify type of operational amplifier. [CLO1]

Non Inverting amplifier [1m]

b) Calculate the output voltage for the circuit if the input voltage is 5V, R a = 1 k and
Rf = 5 k. [CLO2]

R
VO 1 F Vin
RA
[1m]

5k
VO 1 5
1k
[0.5m]

VO 30V
[0.5m]
DEE 3043 ELECTRONIC CIRCUITS

QUIZ 1 (CLO 1 & CLO 2)

ANSWER SCHEME
1) Identify the correct arrangement of DC Power Supply block diagram. [CLO1] [1m]
A. Rectifier, Transformer, Filter, Regulator, Voltage Divider
B. Transformer, Rectifier, Filter, Regulator, Voltage Divider
C. Transformer, Rectifier, Regulator, Filter, Voltage Divider
D. Transformer, Rectifier, Filter, Voltage Divider, Regulator

2) Identify the output voltage produced by the LM7805 regulator. [CLO1] [1m]
A. +5V
B. -5V
C. +12V
D. -12V

3) An op-amp input produces a 0 o voltage phase shift (from input to output) when used as input
signal. Choose the correct input of the op-amp. [CLO1] [1m]
A. Gain input
B. Non-inverting input
C. Differential input
D. Inverting input

4) The true ideal ideal characteristics of an operational amplifier is : [CLO1] [1m]


A. Voltage Gain - 0
B. Input Impedance -
C. Output Impedance - 0
D. Input Offset Voltage -

5) Sketch the input and output waveform for full-wave bridge rectifier. [CLO1]

Input waveform [1.5m] Output waveform [1.5m]

6) Based on figure below:


V in +
V o

Ra Rf

a) Identify type of operational amplifier. [CLO1]

Non Inverting amplifier [1m]

b) Calculate the output voltage for the circuit if the input voltage is 5V, R a=10k and
Rf=20k. [CLO2]

R
VO 1 F Vin
RA
[1m]

20k
VO 1 5
10k
[0.5m]

VO 15V
[0.5m]

You might also like