9/4/2017 Duplicate Line selection and deletion macro - DASSAULT: CATIA products - Eng-Tips
Home Forums Engineering Computer Programs Engineering Programs DASSAULT: CATIA products Forum
Duplicate Line selection and deletion macro
thread560-395758
Read Reply To Start A E-mail Print More Next
New Posts This Thread New Thread Thread Like Thread
Thread This
I am bringing in a 2D profile from an IGS file, the profile has 3700 elements (lines and curves) then it has a totally new set of
lines and curves that form the same profile on top of it. Essentially, its a single geoset with duplicate lines on lines. Is there a
tool in Catia (or custom macro) to isolate only one group of elements that form the profile without going thru each line and
deleting one of them?
I think the operation I'm looking for is similar to "OVERKILL" in AutoCAD...
thanks
K
Post Edited Great post! Report
if it's all 2D:
make a big join (no check connexity - no check manifold)
create a plane offset at 1mm
project the join on the offset plane
isolate the projection 1 (copy paste as result)
delete all but the isolated projection 1
project the isolated projection 1 back on the original plane
isolate the projection 2
delete isolated projection 1
disassemble isolated projection 2
delete isolated projection 2
Eric N.
indocti discant et ament meminisse periti
Great post! Report
Good suggestion to project, I discovered (after you create a smart join) you can project dumb up to the offset plane-
however, you must project along a direction and turn nearest solution off. That will (apparently) get rid of duplicate lines, I'm
not really sure WHY... but it worked so I'm happy.
Thanks for your help!
Great post! Report
Mark Thread for Add E-mail More Top Next
E-mail Notification.. Thread Thread Like of Thread
To Your This Page
Archive
http://www.eng-tips.com/viewthread.cfm?qid=395758 1/2
9/4/2017 Duplicate Line selection and deletion macro - DASSAULT: CATIA products - Eng-Tips
Home > Forums > Engineering Computer Programs > Engineering Programs > DASSAULT: CATIA products Forum
Advertise
Copyright 1998-2017 ENGINEERING.com, Inc. All rights reserved.
Unauthorized reproduction or linking forbidden without expressed written permission. Registration on or use of this site constitutes acceptance of our Privacy
Policy.
http://www.eng-tips.com/viewthread.cfm?qid=395758 2/2
