VIVA QUESTIONS
1) Where is a hub specified in the OSI model?
A. Physical layer
B. Network layer
C. Data link layer
D. Application Layer
2) Which one of the IEEE standards for WiFi has highest data rate?
A. 802.11a
B. 802.11b
C. 802.11g
D. 802.11n
3) What is the center frequency and bandwidth for WiFi ?
A. 900MHz
B. 2.4GHz
C. 3GHz
D. 700MHz
4) The topology with highest reliability is
A. Bus topology
B. Star topology
C. Ring Topology
D. Mesh Topology
5) Baud means
A. The number of bits transmitted per unit time
B. The number of bytes transmitted per unit time
C. The rate at which the signal changes
D. None of above
6) What is the administrative distance of OSPF?
A. 100r
B. 110
C. 128
D. 72
7) How long is an IPv6 address?
A. 32 bits
B. 128 bits
C. 128 bytes
D. 64 bits
8) UDP is
A. Connection based protocol
B. A high Overhead protocol
C. Suited for Data sensitive network
D. Suited for Delay sensitive network
9) OFDM is suited for
A. Flat fading channel
B. Frequency selective fading channel
C. Fast fading channel
D. Slow fading channel
10) Which one of the following is an application layer protocol?
A. AODV
B. CSMA
C. SMTP
D. RIP
11) Which one of the following factor decides the Doppler spectrum of the channel?
A. Signal power
B. Mobility
C. MCS
D. Noise power
12) Which one of the following is a demerit of OFDM technology?
A. PAPR
B. Frequency & Phase offset
C. Physical Over head
D. All the above
13) What is the key size of AES?
A. 128
B. 64
C. 300
D. 16
14) Encapsulation means
A. Pass the packets to the channel
B. Add the header to the packets
C. Modulates the signal
D. None of the above
15) In Qualnet statistics, Server represents
A. Destination
B. Source
C. Router
D. None of the above
16) In Matlab, what is the syntax to generate normal distributed random variable?
A. randi()
B. randn()
C. randvar()
D. rand()
17) The increase in size of network layer header, will affects the network throughput?
A. Yes
B. No
C. It depends on the type of the protocol
18) You have 10 users plugged into ahub running at 10Mbps half-duplex.There is a server
connected to the switch running 10 Mbps half-duplex as well?How much bandwidth does each
host have to the server?
A. 100 Kbps
B. 1Mbps
C. 2Mbps
D. 10Mbps
19) What are the layers that are defined by IEEE standards?
A. Network &MAC
B. DLL and PHY
C. APP and Transport
D. All the above
20) Jitter in multimedia networks refers to
A. Differentiation of throughput w.r.t to time
B. Differentiation of delay w.r.t to time
C. Differentiation of delay in consecutive times
D. None of the above