Scribd
Upload
2K views1 page

Engine Overhaul Manual Wl3 WLC Wec Supplement f198!10!05l19

This document provides instructions for dismounting a Mazda BT-50 engine from an engine stand using an SST (Special Service Tool). It outlines 10 steps, including adjusting the SST bolts so that 20mm of thread is exposed to parallel the plate and arms, tightening the bolts and nuts to affix the SST firmly, removing the engine hanger or SST, and draining the engine oil before removing the drain plug. The final instruction is to dismount the engine in reverse order of mounting.

Uploaded by

staff055
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views1 page

Engine Overhaul Manual Wl3 WLC Wec Supplement f198!10!05l19

This document provides instructions for dismounting a Mazda BT-50 engine from an engine stand using an SST (Special Service Tool). It outlines 10 steps, including adjusting the SST bolts so that 20mm of thread is exposed to parallel the plate and arms, tightening the bolts and nuts to affix the SST firmly, removing the engine hanger or SST, and draining the engine oil before removing the drain plug. The final instruction is to dismount the engine in reverse order of mounting.

Uploaded by

staff055
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

BACK TO CHAPTER INDEX MAZDA BT-50 OVERHAUL MANUAL

TO MODEL INDEX

MECHANICAL [WL-3]
5. Adjust the SST (bolts) so that 20 mm {0.79 in} or
more of thread is exposed. PARALLEL
6. Align the SSTs (plate and arms) so that they are 49 L010 101
parallel by adjusting the SSTs (bolts and nuts). 49 L010 102
7. Tighten the SSTs (bolts and nuts) to affix the SST
49 L010 105
firmly.
8. Mount the engine on the SST (engine stand). ENGINE

Warning
x The self-locking brake system for the
49 L010 104 49 L010 103 APPROX. 20 mm {0.79 in}
engine stand may not operate if the
engine is held in an unbalanced position.
DBG110AEB105
This could lead to sudden, rapid
movement of the engine and mounting
stand handle and cause serious injury. Never hold the engine in an unbalanced position, and
always grasp the rotating handle firmly when turning the engine.

9. Remove the engine hanger (JE48 10 561C) or


SST (303-050 (49 UN30 3050)). 49 0107 680A
10. Drain the engine oil into a container.
11. Install the drain plug using new washer.

Tightening torque
29.441.2 Nm {3.004.20 kgfm, 21.730.3
ftlbf}

End Of Sie

DBG110AEB004

ENGINE DISMOUNTING [WL-3]


DCF011002000W02
1. Dismount in the reverse order of mounting.
End Of Sie

0110A3

You might also like