Scribd
Upload
161 views1 page

Plug Weld Specifications and Guidelines

The document discusses guidelines for plug welds according to AWS D1.1. The diameter of the hole for a plug weld should be the thickness of the plate plus 8mm. The length of the plug and distance between plugs can be calculated following additional rules: the maximum width of the hole is the minimum width plus 3mm or 2.25 times the plate thickness, whichever is greater; the minimum spacing between plug welds is 4 times the hole diameter; and the minimum spacing for slot welds is 4 times the slot width in the transverse direction and 2 times the slot length in the longitudinal direction.

Uploaded by

mohsen_267
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
161 views1 page

Plug Weld Specifications and Guidelines

The document discusses guidelines for plug welds according to AWS D1.1. The diameter of the hole for a plug weld should be the thickness of the plate plus 8mm. The length of the plug and distance between plugs can be calculated following additional rules: the maximum width of the hole is the minimum width plus 3mm or 2.25 times the plate thickness, whichever is greater; the minimum spacing between plug welds is 4 times the hole diameter; and the minimum spacing for slot welds is 4 times the slot width in the transverse direction and 2 times the slot length in the longitudinal direction.

Uploaded by

mohsen_267
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

plug weld https://app.aws.org/forum/topic_show.pl?

tid=7941

American Welding Society Forum Not logged in

Topic Welding Industry / General Welding Discussion / plug weld

By mjf Date 10-26-2005 14:58

i remember that the wide of the plug should be t+8mm (t is plate thickness); can anybody confirm this and tell me how to calculate the length of
the plug and the distance between 2 plugs? i'm on a platform and i have no documentation with me.
regards.

By QCCWI Date 10-26-2005 15:30

Per AWS D1.1


The minimum diameter of the hole for the plug shall be no less than the thickness of the part containing it plus 5/16(8mm) preferably rounded to
the next greater odd 1/16". The maximum width shall equal the minimum width plus 1/8"(3mm) or 2-1/4 times the thickness of the member,which
ever is greater.
For slotted holes it is the same as above except the length of the slot shall not exceed 10 times the thickness of the part containing it.
The minimum center to center spacing for plug welds shall be 4 times the diameter of the hole.
The minimum center to center of slot welds (traverse direction (this way II) shall be 4 times the width of the slot. Longitudinal direction (--) shall
be 2 times the length of the slot.
Hope I do not confuse you with the (II) and the (--).

By mjf Date 10-27-2005 09:47

thanks a lot QCCWI, your has been approved by my costumer.

Topic Welding Industry / General Welding Discussion / plug weld

- General Welding Discussion

1 of 2 26-Mar-18, 5:37 PM

You might also like