Topic 7_3 Antennas
Current Distribution on a thin wire Antenna
For the two-wire balanced (symmetrical)
transmission line, the current in a half cycle of one
wire is of the same magnitude but 1800 out-of-phase
from that in the corresponding half-cycle of the other
wire.
Two-wire transmission line
s<< λ
The fields radiated by the current of each wire are
essentially cancelled by those of the other.
The net result is an almost ideal non-radiating
transmission line.
1
Topic 7_3 Antennas
As the section of the transmission line between
0 = z = l/2 begins to flare, it can be assumed that
the current distribution is essentially unaltered in
form in each of the wires.
The fields radiated by one do not cancel those of the
other.
Therefore ideally there is a net radiation by the
transmission line system.
2
Topic 7_3 Antennas
If the diameter of each wire is very small (d << λ),
the ideal standing wave pattern of the current along
the arms of the dipole is sinusoidal with a null at the
end.
However, its overall form depends on the length of
each arm.
3
Topic 7_3 Antennas
RADIATION PATTERN
antenna radiation pattern / antenna pattern is
defined as “a mathematical function or a graphical
representation of the radiation properties of the
antenna as a function of space coordinates.
In most cases, the radiation pattern is determined in
the farfield region and is represented as a function of
the directional coordinates.
4
Topic 7_3 Antennas
Radiation properties include
power flux density,
radiation intensity,
field strength,
directivity,
phase or polarization
The radiation property of most concern is the two- or
three dimensional spatial distribution of radiated
energy as a function of the observer’s position
along a path or surface of constant radius.
5
Topic 7_3 Antennas
- power pattern is usually plotted on a logarithmic
scale or more commonly in decibels (dB).
power pattern(in dB) represents the magnitude
of the electric or magnetic field, in decibels, as
a function of the angular space.
6
Topic 7_3 Antennas
Radiation Pattern Lobes
major or main,
minor,
side, and
back lobes.
A radiation lobe is a “portion of the radiation pattern
bounded by regions of relatively weak radiation
intensity.”
Radiation lobes and beamwidths of an antenna pattern.
7
Topic 7_3 Antennas
Linear plot of power pattern and its associated lobes and beamwidths
A major lobe (also called main beam) “the
radiation lobe containing the direction of maximum
radiation.” In Figure above the major lobe is pointing
in the θ = 0 direction.
In some antennas, such as split-beam antennas,
there may exist more than one major lobe.
A minor lobe is any lobe except a major lobe. In
Figures above, all the lobes with the exception of the
major can be classified as minor lobes.
A side lobe is “a radiation lobe in any direction
other than the intended lobe.” (Usually a side lobe is
adjacent to the main lobe and occupies the
hemisphere in the direction of the mainbeam.)
8
Topic 7_3 Antennas
A back lobe is “a radiation lobe whose axis makes
an angle of approximately 1800 with respect to the
beam of an antenna.” Usually it refers to a minor
lobe that occupies the hemisphere in a direction
opposite to that of the major (main) lobe.
Minor lobes usually represent radiation in undesired
directions, and they should be minimized.
Side lobes are normally the largest of the minor
lobes.
The level of minor lobes is usually expressed as a
ratio of the power density in the lobe in question to
that of the major lobe.
This ratio is often termed the side lobe ratio or
side lobe level.
Side lobe levels of -20 dB or smaller are usually not
desirable in most applications.
Isotropic, Directional, and Omnidirectional
Patterns
An isotropic radiator is defined as “a hypothetical
lossless antenna having equal radiation in all
9
Topic 7_3 Antennas
directions.” Although it is ideal and not physically
realizable, it is often taken as a reference for
expressing the directive properties of actual
antennas.
A directional antenna is one “having the property
of radiating or receiving electromagnetic waves more
effectively in some directions than in others. This
term is usually applied to an antenna whose
maximum directivity is significantly greater than that
of a half-wave dipole.”
10
Topic 7_3 Antennas
An omnidirectional pattern is then a special type
of a directional pattern.
It is seen that the pattern in Figure above is
nondirectional in the azimuth plane [f(φ),θ = π/2]
and directional in the elevation plane
[g(θ), φ = constant].
This type of a pattern is designated as
omnidirectional, and it is defined as one “having an
essentially nondirectional pattern in a given plane (in
11
Topic 7_3 Antennas
this case in azimuth) and a directional pattern in any
orthogonal plane (in this case in elevation).”
Principal Patterns
For a linearly polarized antenna, performance is
often described in terms of its principal E- and H-
plane patterns.
The E-plane is defined as “the plane containing the
electric field vector and the direction of maximum
radiation,” and the H-plane as “the plane containing
the magnetic-field vector and the direction of
maximum radiation.”
12
Topic 7_3 Antennas
Field Regions
The space surrounding an antenna is usually
subdivided into three regions:
(a) reactive near-field,
(b) radiating near-field (Fresnel) and
(c) far-field (Fraunhofer)
Reactive near-field region is defined as “that
portion of the near-field region immediately
13
Topic 7_3 Antennas
surrounding the antenna wherein the reactive field
predominates.”
For most antennas, the outer boundary of this region
is commonly taken to exist at a distance
λ is the wavelength
D is the largest dimension of the antenna.
Radiating near-field (Fresnel) region is defined as
“that region of the field of an antenna between the
reactive near-field region and the far-field region
wherein radiation fields predominate and wherein the
angular field distribution is dependent upon the
distance from the antenna.
If the antenna has a maximum dimension that is not
large compared to the wavelength, this region may
not exist.
The inner boundary is taken to be the distance
and the outer boundary the distance
14
Topic 7_3 Antennas
Far-field (Fraunhofer) region is defined as “that
region of the field of an antenna where the angular
field distribution is essentially independent of the
distance from the antenna.
If the antenna has a maximum overall dimension D,
the far-field region is commonly taken to exist at
distances greater than 2D2/λ from the antenna
The amplitude pattern of an antenna, as the
observation distance is varied from the reactive near
field to the far field, changes in shape because of
variations of the fields, both magnitude and phase.
15
Topic 7_3 Antennas
Typical changes of antenna amplitude pattern shape from reactive near field
toward the far field.
As the observation is moved to the radiating near-
field region (Fresnel), the pattern begins to smooth
and form lobes.
In the far-field region (Fraunhofer), the pattern is
well formed, usually consisting of few minor lobes
and one, or more, major lobes.
16
Topic 7_3 Antennas
Radian and Steradian
radian the measure of a plane angle
One radian is defined as the plane angle with its
vertex at the center of a circle of radius r that is
subtended by an arc whose length is r.
circumference of a circle of radius r is
C=2 π r
There are 2 π rad i.e (2 π r/r) in a full circle.
Steradian the measure of a solid angle
17
Topic 7_3 Antennas
One steradian is defined as the solid angle with its
vertex at the center of a sphere of radius r that is
subtended by a spherical surface area equal to that
of a square with each side of length r.
area of a sphere of radius r is A = 4 π r2
There are 4 π sr i.e (4 π r2/r) in a closed sphere.
The infinitesimal area dA on the surface of a sphere
of radius r, shown in Figure below is givenby
18
Topic 7_3 Antennas
dA = r2 sinθ dθ dΦ (m2)
Therefore, the element of solid angle dΩ of a sphere
can be written as
dΩ = dA/r2 = sinθ dθ dΦ (sr)
Exercise 1
19
Topic 7_3 Antennas
For a sphere of radius r, find the solid angle (in
square radians or steradians) of a spherical cap on
the surface of the sphere over the north-pole region
defined by spherical angles of
0 ≤ θ ≤ 300 , 0 ≤ Φ ≤ 1800
20
