CSSR
TCH ASSIGNMENT FAILURES
TCH BLOCKING AND SDCCH BLOCKING
TCH BLOCKING
TCH BLOCKING AND SDCCH BLOCKING
TCH ASSIGNMENT FAILURES, SDCCH BLOCKING, SDCCH DROP AND TCH BLOCKING
TCH ASSIGNMENT AND SDCCH BLOCKING
SDCCH BLOCKING
SDCCH DROP
SDCCH DROPS AND TCH ASSIGNMENT FAILURES
SDCCH DROPS AND TCH BLOCKING
SDCCH DROPS AND SDCCH BLOCKING
TCH DROP
TCH DROPS DUE TO LOW SIGNAL STRENGTH UPLINK
TCH DROPS DUE TO LOW SIGNAL STRENGTH DOWNLINK
TCH DROPS DUE TO BAD QUALITY UPLINK
TCH DROPS DUE TO BAD QUALITY DOWNLINK
TCH DROPS DUE TO OTHER REASON
TCH DROPS TO EXCESS TA & LOW SIGNAL STRENGTH
TRX BLOCK
TCH DROPS DUE TO BAD QUALITY AND LOW SIGNAL STRENGTH
TCH DROPS DUE TO SUDDEN LOSS OF CONNECTION
TCH DROPS DUE TO SUDDEN LOSS OF CONNECTION & LOW SS UL/DL
HOSR LOSS
INTERFERENCE ON BCCH
DUE TO LOW COVERAGE
AVOID USING CO & ADJACENT TCH FREQUENCIES IN THE SAME CELL OR SITE
HARDWARE ISSUE
MISSIONG HANDOVER
INTERFERENCE ON TCH
OVERSHOOT OF NEIGHBORING CELLS
FAULT IN TCH TRX
TRANSMISSION ISSUES
OUTAGE
AVOID USING CO TCH ON NEIGHBORING CELLS
CHANGE HSN OR MAIO/MAIO OFFSET
IN CASES WHERE INTRA-CELL HANDOVERS ARE ALLOWED, INTERFERENCE WILL CAUSE A LOT OF INTRACELL
HANDOVERS THUS DEGRADING THE UL & DL QUALITY
TCH REUSE BECOMES TIGHT IS THERE’S A LOT OF OVERSHOOTING OF NEARBY CELLS. ALLOW ONLY 1 OR UP TO 3 DOMINANT SERVERS ONLY.
POOR LEVEL ON THE UPLINK
RX LEVEL VERSUS RX QUALITY DISTRIBUTION PER TRX ON A CELL
ALARM AFFECTING TRAFFIC
AMR RELATED QUALITY ISSUES
INTERFERENCE IN UL
INTERFERENCE IN DL
SD ASSIGNEMENT FAILURE RATE
POOR QUALITY ON DOWN OR UPLINK OR BOTH LINKS
BTS HW faults.
SYNCHRONIZATION OR ABIS LINK FAULT (TRANSMISSION FAULTS)
TCH DROP ACTIONS
SET TALIM TO A VALUE CLOSE TO 63
CHECK TILT ANTENNA/REDUCE ANTENNA HEIGHT/OUTPUT POWER FOR CO-CHANNEL CELLS
CHECK COVERAGE PLOTS AND CHECK OUTPUT POWER
CHECK POWER BALANCE AND LINK BUDGET
CHECK ANTENNA CONFIGURATION & TYPE AND ANTENNA INSTALLATION
PERFORM DRIVE TESTS & SITE SURVEY AND CHECK C/I AND C/A PLOTS, FREQUENCY PLAN (CO-BCCH OR CO-BSIC PROBLEM) AND MAIO, HOP, HSN PARAMETERS
CHECK TRX/TS WITH HIGH CONERRCNT
CHECK FOR EXTERNAL INTERFERENCE
CHECK BTS ERROR LOGS, ALARMS AND FAULT CODES, CONERRCNT PER TRX AND TS AND CHECK FOR DIP SLIPS
CHECK TRANSMISSION LINK
CHECK LAPD CONGESTION
CORRELATE HANDOVER LOST TO DROPS DUE TO SUDDEN LOSS
CHANGE THE BCCH
CHANGE THE TCH
UPGRADE TRX
UPGRADE LINK TRANSMISSION
CHANGE DHA PARAMETER
CHANGE CELLRESELECTION HYSTERISIS PARAMETER
CHANGE CELLRESELECTION OFFSET PARAMETER
CHANGE TEMPORY OFFSET PARAMETER
CHANGE PENALTY TIME PARAMETER
CHANGE MSTXPWR PARAMETER
CHANGE BSXPWR PARAMTER
RADIO PARAMETERS CHANGE
ACTIVE DANAMIC HALF RATE PARAMETER
CHANGE ANTENNA TILT OR AZIMITH
ADD NEIGHBOR CELL RELATION
CHECK MEASUREMENT FREQUENCIES LIST
CHECK NCC PERMITTED
REMOVE BLOCKING ON TAGER CELL
CHECK TCH CONGESTION
CHECK HANDOVER PARAMETERS
CHECK LOCATING PARAMETERS
CHECK COVERAGE PLOTS
CHECK INTER-MSC/BSC HANDOVER PERFORMANCE
TCH CONGESTION ACTIONS
TCH AVAILABILITY ISSUE IMPLEMENT HALF RATE OR DUAL RATE
RADIO RESOURCE LIMITATION CHECK FRL & FRU
TRANSMISSION INSTABILITY UPGRADE TRX
OTHER REASONS CHANGE HARDWARE FAULTY
HIGH UTILIZATION OF TCH CHECK TRANSMISSION LINK
TIME SLOT FAULTY ENABLE DRT
TRX BLOCK CHANGE HO MARGIN
HW PROBLEM UPGRADE TRANSMISSION
LOAD SHARING CORRECTION HANDOVER PARAMETER
INTERFERENCE CLEAN THE ALARM
HANDOVER PROBLEM UNLOCK TRX BLOCK
NEIGHBORS CELL DOWN CHANGE FEEDER AND CONNECTOR
NEIGHBORS SITE DOWN ANTENNA DOWNTIL, MEC OR ELECTRIC
OUTAGE ANTENNA AZIMUTH CHANGE
BAD QUALITY SHARE TRAFFIC
SDCCH DROP
SDCCH DROPS DUE TO LOW SIGNAL STRENGTH DOWNLINK
SDCCH DROPS DUE TO BAD QUALITY DOWNLINK
SDCCH DROPS DUE TO LOW SS & OTHER REASONS
SDCCH DROPS TO EXCESS TA & LOW SIGNAL STRENGTH
SDCCH DROPS DUE TO BAD QUALITY AND LOW SIGNAL STRENGTH
SDCCH DROPS DUE TO BAD QUALITY UPLINK
SDCCH DROPS DUE TO LOW SIGNAL STRENGTH UPLINK
SDCCH DROPS DUE TO EXCESS TA
SDCCH DROPS DUE TO OTHER REASON
MISSING NBR
SDCCH DROP DUE TO HANDOVER FAILURE
SDCCH DROP DUE TO HARDWARE FAULT
SDCCH DROP DUE TO TRANSMISSION
SDCCH DROP DUE TO TRAFFIC INCREASE
SDCCH DROP DUE TO BAD INSTALLATION
HIGH INTREFERENCE OF FREQ.,LIKE CO-CHANNEL
SDCCH TIME SLOT FAULTY
POOR TRX DL QUALITY
HARDWARE FAULT LIKE ANTENNA OR DUPLEXER MALFUNCTION
MAY BE FEEDER CABLE AND CONNECTORS ARE FAULTY.
SITE TAKING CALLS FROM A VERY FAR DISTANCE.
HIGH TIMING ADVANCE
HARDWARE FAULT AT BTS
ACTIONS SDCCH DROP
CHECK C/I AND C/A PLOTS. CHECK FREQUENCY PLAN. PERFORM DRIVE TESTS
CHECK IF THE CELL PARAMETER TALIM IS < STYLE="FONT-WEIGHT: BOLD;">SOLUTION: SET
TALIM TO A VALUE CLOSE TO 63. TILT ANTENNA/REDUCE ANTENNA HEIGHT/OUTPUT POWER, ETC.
FOR COCHANNEL CELLS.
Software Optimization SOFTWARE OPTIMIZATION
Hardware Faulty HARDWARE FAULTY
Coverage Issue COVERAGE ISSUE
Capacity Upgrade CAPACITY UPGRADE
Quality Issue QUALITY ISSUE
Software and Hardware Issue SOFTWARE AND HARDWARE ISSUE
Transmission Optimization TRANSMISSION OPTIMIZATION
Degrow DEGROW
Optimization_Team OPTIMIZATION_TEAM
Back Office_RAN BACK OFFICE_RAN
Back Office_TRM BACK OFFICE_TRM
Back Office_VSAT BACK OFFICE_VSAT
Field Maintenance Eng FIELD MAINTENANCE ENG
Ericsson_Team ERICSSON_TEAM
Optimization_Team and Back Offic OPTIMIZATION_TEAM AND BACK OFFICE_RAN
Optimization_Team and Back Offic OPTIMIZATION_TEAM AND BACK OFFICE_VSAT
Back Office_VSAT and Back Office BACK OFFICE_VSAT AND BACK OFFICE_RAN
Optimization Team
Back Office_TRM
Field Maintenance Eng
Back Office_VSAT
Back Office_RAN
Field Maintenance Eng & Back Office
Opimization Team and Back Office_RAN
Opimization Team and Back Office_VSAT
Field Maintenance Eng and Optimization Team
Back Office_VSAT and Back Office_RAN
BACK OFFICE_RAN
BACK OFFICE_VSAT
ACK OFFICE_RAN
Hardware fault
Hard capacity
Soft Capacity
Transmission Link Issue
Hardware Problem
Hardware fault
Coverage Problem
Soft Parameter Optimization
Poor downlink level
Poor downlink quality
Poor uplink level
Poor uplink quality
No synch between BSC & BTS
VSWR
High B.E.R (Bit error ratio)
check ICM values, FAS recordings, Frequency plan , MRR
check site traffic, serving area…
Check if HO on SDCCH is activated
Check neighboring cells availability
Check SDCCH traffic… perform SDCCH traffic break down… SDCCH used for LAU, SMS, Emergency Calls…
Check site location… if on BSC/ LAC border
HARDWARE FAULT
HARD CAPACITY
SOFT CAPACITY
TRANSMISSION LINK ISSUE
HARDWARE PROBLEM
HARDWARE FAULT
COVERAGE PROBLEM
SOFT PARAMETER OPTIMIZATION
POOR DOWNLINK LEVEL
POOR DOWNLINK QUALITY
POOR UPLINK LEVEL
POOR UPLINK QUALITY
NO SYNCH BETWEEN BSC & BTS
VSWR
HIGH B.E.R (BIT ERROR RATIO)
CHECK ICM VALUES, FAS RECORDINGS, FREQUENCY PLAN , MRR
CHECK SITE TRAFFIC, SERVING AREA…
CHECK IF HO ON SDCCH IS ACTIVATED
CHECK NEIGHBORING CELLS AVAILABILITY
CHECK SDCCH TRAFFIC… PERFORM SDCCH TRAFFIC BREAK DOWN… SDCCH USED FOR LAU, SMS, EMERGENCY CALLS…
CHECK SITE LOCATION… IF ON BSC/ LAC BORDER
MERGENCY CALLS…
