We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 9
PN 111581
OPERATING CA25
Valid from Serial No. 575 001 VIBRATORY ROLLERS
Diese? engine: Deutz Fél 912, >
Caterpillar D3208 NA, GM (Detroit) 3-537, Cummins 6BT 5.9
CONTENTS Page Page
Safety recommendations . Stopping the roller .
Before starting the engine . 3° Parking ....+.
Starting the engine . 4 Lifting instructions
6
7
Driving/vibrating Operating the roller after
Braking ..... been lifted .
ce wows
at
30
5 Fig. 1b
26 Operator's
platform
* Accessories A
** only on the
CA 25 A 33~
wale oh y 4
Fig. 1a. Instrument panel ro
Fig. Ic
1 Temperature gauge - hydraulic of] 17 Throttle
2 Temperature gauge - coolant (CAT) 18 Stop contro! (Deutz)
Sa 19 Direction of travel indicator*
4 Air cleaner warning lamp 20 Working Tights*
5 Tachometer/operating hour meter 21 Rotating beacon*
6 Compaction meter* 22 Driving 1ights*
7 Frequency meter* 23 Hazard lights*
8 Forward/reverse lever 24 Horn
9 Vibration, ON/OFF 25 -
10 Speedometer* 26 Starter switch
11 High/Iow speed 27. Supply switch
2 - 28 Brake warning lamp
13. Amplitude selector 29 Emergency stop
ue 30 041 pressure warning lamp (diesel)
1b - 31 Voltmeter
16 Frequency meter, ON/OFF 32 Fuel gauge
DYNAPAC 0-10200-4 ENG
Dynapac Heavy Equipment AB
PO Box 504-S-371 28 KARLSKRONA-SWEDEN
Tel. 0455-229 30-Telex 43041 dynkar
Telecopier 0455-295 39
‘esr ne ape org otecatony went ace AN SAFETY PRECAUTIONS
READ CAREFULLY
+ READ AND UNDERSTAND OPERATOR'S MANUAL BEFORE START UP.
+ OBSERVE AND FOLLOW ALL MAINTENANCE AND SERVICE INSTRUCTIONS.
- DO NOT OPERATE ROLLER UNLESS QUALIFIED BY TRAINING OR
EXPERIENCE.
. DO NOT OPERATE ROLLER IF IN NEED OF REPAIR OR ADJUSTMENT.
+ OBEY ALL SAFETY RULES.
« VISUALLY INSPECT FOR GROUND HAZARDS.
« TEST ALL CONTROLS, BRAKES AND STEERING BEFORE WORKING,
« BEFORE START UP:
~ SET HANDBRAKE
PLACE FORWARD/REVERSE CONTROL IN NEUTRAL
~ BE FIRMLY AND SECURELY SEATED AT CONTROLS.
ON A GRADE, DO NOT SHIFT TRANSMISSION UNLESS ROLLER IS FULLY
STOPPED WITH EMERGENCY BRAKE ON.
+ USE CAUTION ON UNEVEN SURFACES AND ROUGH TERRAIN.
+ LOOK BOTH WAYS WHEN REVERSING.
+ NO RIDERS ALLOWED.
. DO_NOT GET ON OR OFF MOVING ROLLER; ALWAYS USE PROPER STEPS
AND HAND GRIPS,
. NEVER COAST OR FREE-WHEEL WITH ROLLER.
BEFORE LEAVING ROLLER, ADJUST AND SET PARKING BRAKE, ADJUST
AND SET TRAVEL LEVER IN NEUTRAL, VIBRATION OFF, ENGINE OFF.
- KEEP ROLLER CLEAN; AVOID DIRT AND GREASE ON OPERATOR
PLATFORM.
. KEEP ALL OPERATION PLATES AND DECALS CLEAN AND READABLE.
+ BLOCK ROLLS/TIRES AND FASTEN STEERING LOCK WHEN SERVICING OR
REPAIRING ROLLER.
EXERCISE CAUTION WHEN FUELLING MACHINE:
= SHUT DOWN ENGINE
= NO SMOKING
~~ GROUND FILLER AGAINST TANK NECK TO AVOID A SPARK.
+ DO_NOT MODIFY THIS ROLLER IN ANY WAY WHICH WILL AFFECT SAFETY
WITHOUT DYNAPAC WRITTEN APPROVAL.
CA 25 0-10200 ENG BEFORE STARTING
1 Battery master switch
SPRINKLING
(only applies to the CA 25)
Fig. 3a
1 Filter cock
decd:
Fig. 3b Front water tank
2 Front tank cock
3 Rear tank cock
Ensure that the daily maintenance has been
carried out (see the Maintenance Instructions).
Check that the battery master switch (1) is in
the ON position. Check also that the engine air
intake is not obstructed.
Apply the handbrake by pulling up the lever
upwards.
Check that a gear is engaged with the gear
selector (33).
5 Adjust the operator's seat so that the controls
are easily accessible.
When driving on asphalt, check that the water
tanks are filled and that the filter cock (1) is
open.
When driving on asphalt, cock (2) should be open
and (3) closed.
When pumping from the front tank to the rear tank,
cock (2) should be closed and cock (3) open.
(A 25 0-10200 ENG
