Scribd
Upload
83 views

Release Agent (New)

This document provides information about a release agent used for molding PU, epoxy, and plastic parts. The release agent is a clear liquid with a specific gravity of 0.95±0.05 and viscosity between 100-350 cst at 25°C. It contains 98.5% active ingredients and has a flash point of 280°F. The release agent is a dilutable, solvent-based product that offers multiple releases and lubrication when used for molding. It is described as economic to use with minimal cleaning and an excellent release effect.

Uploaded by

rainer
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
83 views

Release Agent (New)

This document provides information about a release agent used for molding PU, epoxy, and plastic parts. The release agent is a clear liquid with a specific gravity of 0.95±0.05 and viscosity between 100-350 cst at 25°C. It contains 98.5% active ingredients and has a flash point of 280°F. The release agent is a dilutable, solvent-based product that offers multiple releases and lubrication when used for molding. It is described as economic to use with minimal cleaning and an excellent release effect.

Uploaded by

rainer
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

RELEASE AGENT

Technical Product Data


Properties Characteristics
Appearance Clear
Specific Gravity, 25℃ 0.95±0.05
Viscosity, cst, 25℃ 100-350
Active Ingredients, ％ 98.5
Flash Point, Pensky -Martens, ℉ 280
* These items are provided as general information only. They are approximate values
and are not considered part of the product specification.

Application Characteristics
This product is a dilutable、external release Sprayable, solvent based release agent.
agent. It offers multiple released and
lubricating properties when mould PU (Ether Advantage
and Ester systems), or Epoxy, Plastic parts.  Economic in use.
Suitable for Inner Elastomers, Soles, Rigid  Minimal cleaning stops.
foam, Integral Skin, TPU,…  Excellent release effect.
 Dry and glossy surface finish.
Preparation
Our release agent is a concentrate. As a rule Storage
dilutable 1:20-35 with e.g. Iso-hexane, 1. 1.1. Approx. 1 year. The release agent should be
-T.C.E., M.C….. always kept in sealed drums.

TAIWAN PU CORPORATION
3F-1, No. 9, Wu-Chuan 1st Road, Sinjhuang District, New Taipei City, Taiwan(New Taipei Industrial Park)
TEL:886-2-2299-1666 FAX:886-2-2299-1888
E-MAIL: [email protected] WEBSITE: www.taiwanpu.com

You might also like