Scribd
Upload
662 views

Valve Clearance Inspection (WL-C, We-C) : B A B A

This document provides instructions for inspecting valve clearances on an engine. It involves removing parts to access the valves, turning the crankshaft to top dead center, measuring clearances with a feeler gauge, adjusting if needed, replacing parts, and adjusting the drive belt. Clearances should be within specified ranges and adjusting the valves ensures proper engine operation.

Uploaded by

JeremyArgel
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
662 views

Valve Clearance Inspection (WL-C, We-C) : B A B A

This document provides instructions for inspecting valve clearances on an engine. It involves removing parts to access the valves, turning the crankshaft to top dead center, measuring clearances with a feeler gauge, adjusting if needed, replacing parts, and adjusting the drive belt. Clearances should be within specified ranges and adjusting the valves ensures proper engine operation.

Uploaded by

JeremyArgel
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

VALVE CLEARANCE INSPECTION [WL-C, WE-C]

id0110b6803400

1. Remove the engine cover.


2. Remove the following parts to turn the crankshaft.
1. Drive belt. (See DRIVE BELT ADJUSTMENT [WL-C, WE-C].)
2. Cooling fan. (See COOLING FAN REMOVAL/INSTALLATION [WL-C, WE-C].)
3. Water pump pulley.
3. Remove the fuel injector. (See FUEL INJECTOR REMOVAL/INSTALLATION [WL-C, WE-C].)
4. Remove the cylinder head cover.
5. Turn the crankshaft and align the timing mark so that the piston of the No. 1 or No. 4 cylinders is at TDC of
compression.
6. Measure valve clearances A with the No.1 cylinder at TDC of compression, and those of B with the No.4 cylinder
at TDC of compression.
• If it is not within the specification, adjust and recheck the valve clearance. (See VALVE CLEARANCE
ADJUSTMENT [WL-C, WE-C].)
B A B A

EX

ENGINE
FRONT

IN

B B A A
dbg110beb023

CAMSHAFT
Valve clearance [Engine cold] FEELER
IN: 0.10—0.16 mm {0.0040—0.0062 in} GAUGE ADJUST SCREW
EX: 0.17—0.23 mm {0.0067—0.0090 in}
LOCKNUT
7. Turn the crankshaft one full turn and measure the
remaining valve clearances. Adjust if necessary.
8. Install the cylinder head cover. (See CYLINDER
HEAD GASKET REPLACEMENT [WL-C, WE-C].)
9. Install the fuel injector. (See FUEL INJECTOR
REMOVAL/INSTALLATION [WL-C, WE-C].)
ROCKER ARM
10. Install the water pump pulley, cooling fan and drive
belt. dbg110btbrr5

11. Adjust the drive belt deflection. (See DRIVE BELT ADJUSTMENT [WL-C, WE-C].)
12. Install the engine cover.

You might also like