0% found this document useful (0 votes)
107 views10 pages

Remote Control Encoder Specs

PT2265 is a remote control encoder that uses CMOS technology. It can encode signals from up to 8 input channels and transmit encoded signals with high noise immunity. The encoder has low power consumption and transmits signals at 38 kHz. It requires an external 455 kHz oscillator circuit. The encoder outputs a start word followed by 3 identical data words when an input channel is activated.

Uploaded by

kindboomer
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
107 views10 pages

Remote Control Encoder Specs

PT2265 is a remote control encoder that uses CMOS technology. It can encode signals from up to 8 input channels and transmit encoded signals with high noise immunity. The encoder has low power consumption and transmits signals at 38 kHz. It requires an external 455 kHz oscillator circuit. The encoder outputs a start word followed by 3 identical data words when an input channel is activated.

Uploaded by

kindboomer
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 10

Tel: 886-2-29162151

Princeton Technology Corp. Fax: 886-2-29174598


URL: http://www.princeton.com.tw

Remote Control Encoder PT2265

PT2265 is a remote control encoder paired with PT2275 utilizing CMOS


Technology. Using a special coding technique, PT2265 increases noise immunity to
a very great extent and can perform one bit error check. It is housed in 14-pins, DIP
Package and has a maximum of eight (8) input channels. Its high performance
features make PT2265 a MUST in every fan and other electrical home appliance
remote control application.

r CMOS Technology
r Low Power Consumption
r Very High Noise Immunity
r Operating Voltage : Vcc = 2.2 ~ 5.0 Volts
r Transmits signals to a maximum of 8 channels
r Start Word Custom Code Options Available (Please contact PTC for details.)

r Fan Remote Control


r Air Cleaner
r Humidifier
r Heater

Note: PT2265 has been updated and can be identified by the “B” mark on the lower
right hand corner of the IC’s topcode (beside the date code). Please refer to the
diagram on the Order Information Section The difference between the old and new
version is the external application circuit in the OSC1 and OSC2 pins. (see
Oscillator Section)

PT2265 v 2.3 Page 1 Revised Sept. 1998


Tel: 886-2-29162151
Princeton Technology Corp. Fax: 886-2-29174598
URL: http://www.princeton.com.tw

Remote Control Encoder PT2265

PT2265 v 2.3 Page 2 Revised Sept. 1998


Tel: 886-2-29162151
Princeton Technology Corp. Fax: 886-2-29174598
URL: http://www.princeton.com.tw

Remote Control Encoder PT2265

Pin Name I/O Description Pin No.


I1 ~ I8 I Key Input Pins 1~8
These keys are used to connect a maximum of 8 keys.
(Each key has a built-in pull-low resistor)
Vss Negative Power Supply 9
TxOUT O Transmission Output Pin. 10
This pin is an open drain (NMOS) output and is used
to transmit signals. The carrier frequency is 38 KHz
OSC1 I Oscillator Pin No.1 These pins are used to 13
externally connect a
OSC2 O Oscillator Pin No. 2 455 KHz Ceramic 12
Resonator.
Vcc Positive Power Supply 14
NC - No Connection 11

Up to eight (8) keys can be directly connected to pins I1 ~ I8. Please refer to the
diagram below.

Figure 1: PT2265 Key Input Connections

Furthermore, PT2265 has a built-in pull-low resistor of about 30 K ~ 80 K Ω which


reduces the need for external components.

PT2265 v 2.3 Page 3 Revised Sept. 1998


Tel: 886-2-29162151
Princeton Technology Corp. Fax: 886-2-29174598
URL: http://www.princeton.com.tw

Remote Control Encoder PT2265

An oscillation circuit can be constructed using the following:


1. CMOS Inverter
2. 455 KHz Crystal
3. For PT2265 New Version (with B Mark)
a.) 2 Capacitors (150 ~ 1800 pF)
4. For PT2265 Old Version
a.) 100 pF Capacitor
b.) 10 M Ω feedback resistor
Please refer to the following diagrams.

PT2265 New
(with "B: Mark)
OSC1 OSC2

C1 455 KHz C2
220pF 220pF

Figure 2: PT2265 New Version (with “B” Mark”) Oscillation Circuit Diagram

P2265

OSC1 OSC2

10M Ohms

455 KHz
100pF

Figure 3: PT2265 Old Version Oscillation Circuit Diagram

PT2265 v 2.3 Page 4 Revised Sept. 1998


Tel: 886-2-29162151
Princeton Technology Corp. Fax: 886-2-29174598
URL: http://www.princeton.com.tw

Remote Control Encoder PT2265

Unless any of the 8 keys (I1 ~ I8) is being operated, the oscillation is automatically
stopped. Thus, power consumption is considerably reduced.

When any of the 8 keys (I1 ~ I8) is set to “HIGH”, The TxOUT outputs one Start
Word followed by three (3) Identical Data Words. However, the other keys will
NOT operate if this key (that was set to “HIGH”) is not released. Please refer to
the following diagram.

Figure 4: PT2265 Word Frame Diagram

The transmission code waveforms are illustrated below:

Figure 5: PT2265 Transmission Code Waveform Diagram

PT2265 v 2.3 Page 5 Revised Sept. 1998


Tel: 886-2-29162151
Princeton Technology Corp. Fax: 886-2-29174598
URL: http://www.princeton.com.tw

Remote Control Encoder PT2265

The transmission code pattern of PT2265 is given in the table below.

Transmission LSB MSB Receiver


C0 C1 C2 C3 C4 C5 C6 C7
Start Word 0 0 1 1 0 0 1 1
B0 B1 B2 B3 B4 B5 B6 B7
Data Word W1 (I1) 0 0 1 1 1 0 1 0 O/p1
(Key pressed) W2 (I2) 0 1 0 1 1 0 0 0 O/p2
W3 (I3) 0 1 1 0 0 0 1 0 O/p3
W4 (I4) 1 0 0 1 1 1 0 0 O/p4
W5 (I5) 1 0 1 0 0 1 1 0 O/p5
W6 (I6) 1 0 1 1 0 0 0 1 O/p6
W7 (I7) 1 1 0 0 0 1 0 1 O/p7
W8 (I8) 1 1 0 1 0 0 1 0 O/p8

where O/p = Output Pin

PT2265 v 2.3 Page 6 Revised Sept. 1998


Tel: 886-2-29162151
Princeton Technology Corp. Fax: 886-2-29174598
URL: http://www.princeton.com.tw

Remote Control Encoder PT2265

Parameter Symbol Rating


Supply Voltage Vcc 0 ~ 6.0 V
Input/Output Voltage Vin/Vout Vss - 0.2 ~ Vcc + 0.3 V
Power Dissipation PD 500 mW
Operating Temperature Topr -20 oC ~ 70 oC
Storage Temperature Tstg -55 oC ~ 125 oC

Normal Operating Condition: T = 0oC ~ +70 oC, Vcc - Vss = 3V + 10%

PARAMETER SYMBOL CONDITION MIN. TYP. MAX. UNIT


Operating Vcc 2.2 3 5 V
Voltage
Operating IOP OSC On 500 1000 µA
Current TxOUT is floating
(See Note 1)
Stand-by Current ISB I1 ~ I8 = “L” 0.5 1 3 µA
OSC Stops.
TxOUT is floating.
Sinking Current I SINK VO L=2.2 V 8 15 mA
of TxOUT VOL=1.5 V 4 6
Input Voltage of VIH 0.7Vcc - Vcc V
I1 ~ I8 VIL 0 - 0.3Vcc
Input Pull-Low RPL 30 50 80 KΩ
Resistor
OSC Frequency 455 KHz
Note: 1 – For pins I1~I8, one is set to HIGH while the others are set to LOW.

PT2265 v 2.3 Page 7 Revised Sept. 1998


Tel: 886-2-29162151
Princeton Technology Corp. Fax: 886-2-29174598
URL: http://www.princeton.com.tw

Remote Control Encoder PT2265

PT2265 New Version (with “B” mark near Date Code) IR Transmitter Application
Circuit
+ +
3V
47uF(see Layout Note)

I1 Vcc
455 KHz 220pF
I2 OSC1

I3 OSC2
220pF
I4 NC 4.7 Ohm

I5 TXOUT
IR LED
I6 Vss

I7 I8

PT2265 1K

PT2265 Old Version IR Transmitter Application Circuit

+
3V
+
47uF(see Layout Note)

I1 Vcc
455 KHz
I2 OSC1
10M
I3 OSC2

I4 NC 100pF 4.7 Ohm

I5 TXOUT
IR LED
I6 Vss

I7 I8

PT2265 1K

Layout Note: Place the 47uF Capacitor as close as possible to the PT2265's Vcc Pin & GND.

PT2265 v 2.3 Page 8 Revised Sept. 1998


Tel: 886-2-29162151
Princeton Technology Corp. Fax: 886-2-29174598
URL: http://www.princeton.com.tw

Remote Control Encoder PT2265

Part Number Package


PT2265 14 Pins, DIP

The New Version of PT2265 is identified by the “B” Mark on the lower right hand
corner of the topcode. Please refer to the following diagram:

PT2265 v 2.3 Page 9 Revised Sept. 1998


Tel: 886-2-29162151
Princeton Technology Corp. Fax: 886-2-29174598
URL: http://www.princeton.com.tw

Remote Control Encoder PT2265

14 Pins, DIP Package

Symbol Dimension in Mil

A 750

B 65

C 55

PT2265 v 2.3 Page 10 Revised Sept. 1998

You might also like