Small, lightweight, 35 mm DIN rail mountable enclosure with

UL94 V0 flame retardant rating

Low power: 1 - 2 W (netSP), 2 - 3 W (netSP+)

Management of up to 4 netADC's per netSP/netSP+

Decimation of netADC data for improved dynamic range

Continuous, STA/LTA, Adaptive Spectral Triggering (AST)1 or

Threshold triggering algorithms

Intelligent Data Prioritisation: dynamically adjusts data through-

put to the available communications bandwidth (associated
triggers are favoured, followed by triggered and then
un-triggered waveforms)

Multi-station Networked, or Standalone operating modes

Communications: 10/100Base-TX Ethernet, TCP/IP, Waveforms

over Ethernet (WoE), DSL, WiFi Radio, Fibre, Serial or Cellular
modem (GSM,3G, etc.)

Built-in IMS WoE switch distributes timing to downstream

devices over same CAT5 cable as used for data (saves cabling)

Internal data storage: 4 MB (netSP), up to 32 GB (netSP+)

External storage to USB device (e.g. memory stick, external

hard drive, etc.), with optional data compression

General purpose, non-seismic I/O: 7 individually configurable

channels (digital input, digital output or ADC input)

Web interface for device status monitoring, configuration

and control

Remotely upgradable firmware via Synapse or Web interface

On-board temperature measurement and readout

EXTERNAL INTERFACES
ELECTRICAL: 4 Ethernet switch ports (10/100Base-TX) with Auto-MDIX
Supply voltage ..................................................... 9 - 18 V DC (auto-crossover) functionality for setup and telemetry
Power consumption2 .....................................................1 - 3 W USB 2.0: full-speed (netSP), high-speed (netSP+)
RS-232 (3-wire) port for monitoring and distribution of time
MEMORY:
synchronisation signal (ATU/PPS)
netSP............................................................................128 MB
netSP+........................................................................ 256 MB RS-232 (3-wire) console port
RS-485 port for general purpose use
CPU: RS-232 (7-wire) port for external serial modem or GPS
Speed (netSP)...........................................................179 MHz time-synchronisation via NTP
Speed (netSP+)........................................................ 800 MHz
7 individually configurable, non-seismic I/O channels (digital
Architecture (netSP)........................................................ ARM
Architecture (netSP+)........................................................ x86 input, digital output or 10-bit ADC input)
DC power and feed-through
PHYSICAL: 6 user LEDs
Mass (netSP)................................................................. 550 g 4 user push buttons
Mass (netSP+)............................................................... 650 g
Dimensions: NOTES:
Height.....................................................................180 mm 1
Adaptive Spectral Triggering only available on netSP+.
Width.........................................................................52 mm 2
1 - 2 W (netSP), 2 - 3 W (netSP+). Power consumption is an average measurement,
Depth......................................................................165 mm and depends on specific configuration.
3
3 To avoid voiding of equipment warranty, the external enclosure should have an Ingress
Environment...................................requires external enclosure Protection Rating of at least IP65. Suitable, customised, pre-wired enclosures are
available from IMS upon request.
Temperature:
Operating............................................................... 0 - 70°C
Specification subject to change without prior notice. Refer to
http://www.imseismology.org/notices for important information about equipment installation and
NSP-DOC-001 rev0/2011-12-13 warranty conditions, as well as the most recent product specifications.