Scribd
Upload
602 views4 pages

171 - New CAN-filter For Cran Com. SCS4 and Midrange

This technical bulletin introduces a new CAN filter for crane communication to replace existing polyswitches, cables, and transient protection devices. The CAN filter mounts on a standard DIN rail, protects the CAN bus from transients and faulty wiring, and has a built-in 120 ohm CAN termination resistor that can be enabled or disabled via a dip switch. It automatically connects the CAN ground potential to the DIN rail but also allows for separation if needed.

Uploaded by

Mohamed Elnagdy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
602 views4 pages

171 - New CAN-filter For Cran Com. SCS4 and Midrange

This technical bulletin introduces a new CAN filter for crane communication to replace existing polyswitches, cables, and transient protection devices. The CAN filter mounts on a standard DIN rail, protects the CAN bus from transients and faulty wiring, and has a built-in 120 ohm CAN termination resistor that can be enabled or disabled via a dip switch. It automatically connects the CAN ground potential to the DIN rail but also allows for separation if needed.

Uploaded by

Mohamed Elnagdy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Bromma Technical Bulletin No:171

Author: Leif Aveklint Date (yy-mm-dd) 2017-07-03


Fredrik
Spreader type: All with SCS4 and Midrange Approved by Löwenhielm

Hydraluic Electrical Mechanical

Material General Sales support


New CAN-filter for Cran com. SCS4 and Midrange
Topic:

CAN filter for crane communication BR1704458


The CAN filter is designed for mounting on a standard DIN-rail. It is designed to protect the
CAN bus against transients and faulty wiring.
This CAN filter will replace Polyswitch BR1027832, IFM cable with built-in resistor
BR1028280 and in some case also Phoenix Transient protection BR1020915/1020916
See picture below.
.

The CAN filter automatically connects the CAN GND potential to


the same potential as the DIN-rail. If there is a need for DIN-rail
and CAN GND separation: simply remove the screw.

The CAN filter has a built in CAN termination resistor (120ohm).


The CAN termination can be enabled or disabled by sliding
the DIP-switch in the ON or OFF position.
ON = CAN termination enabled
OFF = CAN termination disabled

Please note that the earth


connections “CAN GND” and
“+VBB GND” must be
connected to the same
potential
BR1027832

BR1028280

BR1020915
BR1020916

You might also like