Product data sheet 6EP1332-4BA00

SIMATIC PM 1507 24 V/3 A STABILIZED POWER SUPPLY

FOR SIMATIC S7-1500 INPUT: 120/230 V AC OUTPUT: 24
V/3 A DC

Technical specifications

Product S7-1500 PM1507

Power supply, type 24 V/3 A

Input

Input 1-phase AC

Supply voltage / 1 / at AC / nominal value 120 V

Supply voltage / 2 / at AC / nominal value 230 V

Voltage range

• Note Automatic range selection

Input voltage / 1 / at AC 85 … 132 V

Input voltage / 2 / at AC 170 … 264 V

Wide-range input No

Overvoltage resistance 2.3 × Vin rated, 1.3 ms

Mains buffering at Iout rated, min. 20 ms

Mains buffering at Vin = 93/187 V

Rated line frequency 50 / 60 Hz

Rated line range 45 ... 65 Hz

Input current / at nominal level of the input voltage 120 V 1.4 A

Input current / at nominal level of the input voltage 230 V 0.8 A

Switch-on current limiting (+25 °C), max. 23 A

Duration of current limiting / at 25 °C / maximum 3 ms

6EP1332-4BA00 subject to modifications

Page 1/ 4 07/21/2014 © Copyright Siemens AG 2014
I²t, max. 1.3 A²·s

Built-in incoming fuse T 3,15 A/250 V (not accessible)

Protection in the mains power input (IEC 898) Recommended miniature circuit breaker: 10 A characteristic B or 6 A
characteristic C

Output

Output Controlled, isolated DC voltage

Rated voltage Vout DC 24 V

Total tolerance, static ± 1%

Static mains compensation, approx. 0.1 %

Static load balancing, approx. 0.1 %

Residual ripple peak-peak, max. 50 mV

Spikes peak-peak, max. (bandwidth: 20 MHz) 150 mV

Product feature / output voltage adjustable No

Status display LED green for 24 V OK; LED red for error; LED yellow for stand-by

On/off behavior No overshoot of Vout (soft start)

Startup delay, max. 1.5 s

Voltage rise, typ. 10 ms

Rated current value Iout rated 3A

Current range 0…3A

delivered active power / typ. 72 W

short-term overload current / at short-circuit during run-up / typical 12 A

Duration of overloading ability for excess current / on short-circuiting 70 ms

during the start-up

short-term overload current / at short-circuit during operation / typical 12 A

Duration of overloading ability for excess current / on short-circuiting 70 ms

during the operational phase

Parallel switching for enhanced performance Yes

• Note Parallel switching of 3 A and 8 A possible, devices must be switched

on at the same time, max. 75% per device with I-load

Numbers of parallel switchable units for enhanced performance 2

Efficiency

Efficiency at Vout rated, Iout rated, approx. 87 %

Power loss at Vout rated, Iout rated, approx. 11 W

Closed-loop control

Dynamic mains compensation (Vin rated ±15 %), max. 0.1 %

Dynamic load smoothing (Iout: 50/100/50 %), Uout ± typ. 1%

Dynamic load smoothing (Iout: 10/90/10 %), Uout ± typ. 3%

Load step setting time 10 to 90%, typ. 5 ms

Load step setting time 90 to 10%, typ. 5 ms

Setting time / maximum 5 ms

6EP1332-4BA00 subject to modifications

Page 2/ 4 07/21/2014 © Copyright Siemens AG 2014
Protection and monitoring

Output overvoltage protection Additional control loop, limitation (closed loop control) at < 28.8 V

Current limitation 3.15 … 3.6 A

Current limitation, typ. 3.4 A

Characteristic feature of the output / short-circuit protected Yes

Short-circuit protection Electronic shutdown, automatic restart

Overload/short-circuit indicator -

Safety

Primary/secondary isolation Yes

Potential separation Safety extra-low output voltage Uout acc. to EN 60950-1 and EN
50178 and EN 61131-2

Protection class Class I

stray current / maximum 3.5 mA

stray current / typical 0.4 mA

CE mark Yes

UL/CSA approval Yes

UL/cUL (CSA) approval cULus-Listed (UL 508, CSA C22.2 No. 142), File E143289

Explosion protection ATEX (EX) II 3G Ex nA nC IIC T4 Gc; cULus (ISA 12.12.01, CSA
C22.2 No.213) Class I, Div. 2, Group ABCD, T4, File E330455

FM approval Class I, Div. 2, Group ABCD, T4

CB approval Yes

Marine approval DNV

Degree of protection (EN 60529) IP20

EMC

Emitted interference EN 55022 Class B

Supply harmonics limitation EN 61000-3-2

Noise immunity EN 61000-6-2

Operating data

Ambient temperature / in operation 0 … 60 °C

• Note with natural convection

Ambient temperature / on transport -40 … +85 °C

Ambient temperature / in storage -40 … +85 °C

Humidity class according to EN 60721 Climate class 3K3, no condensation

Mechanics

Connection technology Screw-/spring clamp connection

Connections / Supply input L, N, PE: 1 screw terminal each for 0.5 ... 2.5 mm²

Connections / Output L+, M: 2 spring-loaded terminals each for 0.5 to 2.5 mm²

Width / of the housing 50 mm

Height / of the housing 147 mm

Depth / of the housing 129 mm

6EP1332-4BA00 subject to modifications

Page 3/ 4 07/21/2014 © Copyright Siemens AG 2014
Installation width 50 mm

Mounting height 205 mm

Weight, approx. 0.45 kg

Product feature / of the housing / housing for side-by-side mounting Yes

Mounting type / wall mounting No

Type of mounting / standard rail mounting No

Mounting type / S7 rail mounting Yes

Installation Can be mounted onto S7-1500 rail

Other information Specifications at rated input voltage and ambient temperature +25
°C (unless otherwise specified)

letzte Änderung: Jul 7, 2014

6EP1332-4BA00 subject to modifications

Page 4/ 4 07/21/2014 © Copyright Siemens AG 2014