Scribd
Upload
129 views3 pages

Optimize Water Hardness with Sialex®

The document discusses how a Sialex® ring can be used to prevent scaling in water pipes. In an ideal situation without scaling, the water hardness measured entering a pipe would be equal to the water hardness measured exiting the pipe. However, when installing a Sialex® ring onto an already scaled pipe, there would initially be more scale particles detected in the exiting water along with a gradual increase in water hardness over time, until reaching a point where the entering and exiting water hardness levels are equal, indicating the pipe has been cleaned of scale. A similar process would occur when installing a Sialex® ring onto a previously cleaned pipe system to maintain the prevention of scale buildup over time.

Uploaded by

nascas
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
129 views3 pages

Optimize Water Hardness with Sialex®

The document discusses how a Sialex® ring can be used to prevent scaling in water pipes. In an ideal situation without scaling, the water hardness measured entering a pipe would be equal to the water hardness measured exiting the pipe. However, when installing a Sialex® ring onto an already scaled pipe, there would initially be more scale particles detected in the exiting water along with a gradual increase in water hardness over time, until reaching a point where the entering and exiting water hardness levels are equal, indicating the pipe has been cleaned of scale. A similar process would occur when installing a Sialex® ring onto a previously cleaned pipe system to maintain the prevention of scale buildup over time.

Uploaded by

nascas
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Ideal world : Scale entering = Scale leaving

scale

Water Water
“hardness” “hardness”
measured measured
entering pipe exiting
water circuit water circuit
= “X” Ideal situation = “X”

time
Ex. Water “hardness “ measured at point where water enters the specific water circuit (pipe) = 250mg/L
Water “hardness” measure at point where water leaves the specific water circuit (pipe) = 250mg/L

Therefore: “In water” 250mg/L (CaCo3)


Less “Out water” 250mg/L (CaCo3)
Scale in pipe (CaCo3) “0”
Installation Sialex®Ring onto already “Scaled” water circuit

Sialex®Ring existing pipes


scale Initially notice more „Scale“ particles passing through water pipes.
Also gradual increase in „Hardness“ (CaCo3) in water leaving circuit.
Then a gradual decrease over time until a point where:
“hardness in“ is ideally equal to “Hardness out“ .

Incoming water Exiting water


(to water circuit) (to water circuit)

285mg/L Peak of cleaning effect 285mg/L

Typical Ideal situation


pipe

Installation of a Sialex® Ring


time

250mg/L

Exiting water
(before Sialex® installed)
Installation Sialex®Ring onto already “Cleaned” System
Where historically “Scaling ” occurs over time

scale
Sialex®Ring existing pipes

Incoming water Exiting water


(to water circuit) (to water circuit)

285mg/L 285mg/L

Typical Ideal situation


pipe

time
Water Circuit cleaned of „Scale“ deposits
Installation of a Sialex® Ring
250mg/L

Exiting water
(before Sialex® installed)

You might also like