Scribd
Upload
177 views1 page

NUX Solid Studio Firmware Update Guide

This document provides instructions for updating the firmware on a NUX Solid Studio pedal. It involves downloading the firmware update file to a computer, connecting the pedal to the computer with a USB cable, running update software on the computer, and waiting for the update process to complete, indicated by the pedal's LED lights. The process warns not to disconnect anything during the update.

Uploaded by

Taufan Openx Lukmansyah
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
177 views1 page

NUX Solid Studio Firmware Update Guide

This document provides instructions for updating the firmware on a NUX Solid Studio pedal. It involves downloading the firmware update file to a computer, connecting the pedal to the computer with a USB cable, running update software on the computer, and waiting for the update process to complete, indicated by the pedal's LED lights. The process warns not to disconnect anything during the update.

Uploaded by

Taufan Openx Lukmansyah
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

    : Download the the Firmware     : Connect To Computer

A.Connect your NUX Solid Studio to your Mac or PC computer using a Micro-USB cable
Download the the Firmware Update kit from the website using a PC or Mac

    : Get ready for the update     : Start updating

Power Power

USB
USB

Once the Pedal is connected both LED


indicators will start to blink..
Once the Pedal is connected both LED
indicators will start to blink.. A B

A.Select the new firmware .bin file B.Click “Start update” button

A.Run “NUX DFU Updater” B.Keep holding down both foot-switches and plug in
your power supply( 9V DC Negative Center), release
both foot-switches until you see the pedal is connected.

    : Wait until the progress ends     : Finish updating

Warning: DO NOT UNPLUG The Micro-USB Cable nor the POWER SUPPLY !

Power

USB

A.Close “NUX DFU Updater”


B.UnPlug Power Supply and Micro- USB Cable from the Pedal.
During updating process, both LED indicators will keep flashing C.Hook the Pedal to your pedal board again and try out the new features and tones.
and once the progress is done both LED indicators will stay on.

You might also like