Transmission: Chrysler A604 (41TE), A606 (42LE) Transmission Code: 030
Jeep 42RLE
Dedicated Harness Sets: 03X201 (A604) Rev. A
03X202 (A606) Rev. A
03X209 (42RLE)
SOLENOID TEST: (Engine off)
Solenoid TranX Output AMPS Resistance
Setting Channel Cold-Hot Cold-Hot
2-4 Clutch Gear 1 1 0 - (1.8 - 2.5) 1-3Ω
Duty MIN - MAX
Low/Reverse Gear 2 2 0 - (1.8 - 2.5) 1-3Ω
Clutch Duty MIN - MAX
Overdrive Gear 3 3 0 - (1.8 - 2.5) 1-3Ω
Clutch Duty MIN - MAX
Underdrive Gear 4 4 0 - (1.8 - 2.5) 1-3Ω
Clutch Duty MIN - MAX
CAUTION: CAUTION:
Always come to a COMPLETE STOP & Do not operate vehicle unless all 4
TURN ENGINE OFF before changing test modes solenoids read correct current
SHIFT/MONITOR TEST
2-4 Low/Reverse Overdrive Underdrive
GEAR Clutch Clutch Clutch Clutch
(pulsed) (pulsed) (pulsed) (pulsed)
(Lockup 2nd, 3rd & 4th)
1st ON ON OFF OFF
2nd OFF OFF OFF OFF
3rd ON OFF ON OFF
4th OFF OFF ON ON
Notes:
♦ Set Pressure Duty Cycle between 30 & 50% for firm shifts.
♦ Underdrive is momentarily bumped on during change to 1st to ensure correct operation.
♦ Low/Reverse Clutch Solenoid is controlled by Lock Up Switch in 2nd, 3rd and 4th gears to allow Lock
Up engagement. Lock Up Switch will not work in 1st gear.
♦ EPC Duty cycle controls duty cycle for all 4 solenoids in both shift test and solenoid test. Set to 50% in
solenoid test. Resistance will read 2x actual value.
♦ Polarity = Common Positive
TranX 2000 Manual Chrysler: Page 1
Transmission: Chrysler A604 (41TE), A606 (42LE)
Jeep 42RLE
Pressure Switch Settings
Gear Low Rev. Pres. Switch 2-4 Pressure Switch Overdrive Pres. Switch
(Sensor 1) (Sensor 2) (Sensor 3)
1st GREEN Red Red
2nd (no lock up) Red GREEN Red
3rd (no lock up) Red Red GREEN
4th Red GREEN GREEN
CONNECTORS:
(Looking into harness connectors)
7 8 1 2 7 8 1 2
5 1
10 6
6 5 4 3 6 5 4 3
A604 (41TE) A606 (42LE) 42RLE
Wiring Chart
Case Connector Pin Number TranX 2000 Vehicle Function TranX 2000 TranX 2000
A604 A606 42RLE Harness Wire Output Location 25 Way Pin
1 2 5 White 2-4 Pressure Switch Sensor 2 LED 16
(Yellow) (1 ECU only)
2 3 10 Orange Low Reverse Sensor 1 LED 15
Pressure Switch
3 6 6 Green/White Over Drive Sensor 3 LED 17
(Gray) Pressure Switch (2 ECU only)
4 4 3 Red +12 V to solenoids 12
4 4 3 Red/Brown Stripe +12 V to solenoids 13
5 8 2 Green/Red Stripe Underdrive Output Channel 4 6
Solenoid
6 7 1 Pink Overdrive Output Channel 3 5
Solenoid
7 1 7 Green Low Reverse/Lock Output Channel 2/ 8
Up Solenoid Lock Up Switch
8 5 4 Blue 2-4 Solenoid Output Channel 1 7
TranX 2000 Manual Chrysler: Page 2