PUBSCA101V2
TECHNICAL MANUAL
CEILING MOUNT SPEAKER, 6WATTS
MODEL: SCA-101
SPECIFICATIONS
Description Ceiling Mount Speaker
Rated Power Output 6 Watts
Input Type 8 Ohms or 100Vline
Frequency Response 120 - 15000 Hz
SPL (1Watt/Meter) 86 dB
Speaker Unit 6 Inches, Full Range
Material/Color Speaker Module (Steel/White), Dome (Steel/Red)
Dimension 230mm (Diameter) x 127mm (Depth)
Mounting In-ceiling spring clip quick installation
Weight 900g
WWW.COMTROL.COM.SG 1|Page
PUBSCA101V2
ORDERING OPTIONS
OPTIONS DESCRIPTIONS
/I 8 Ohms Type
/T 100Vline Type (With Transformer)
/M Multiple Tapping: 1.5/3/6 Watts (For 100Vline type only)
WWW.COMTROL.COM.SG 2|Page
PUBSCA101V2
SPEAKER CHARACTERISTICS
WWW.COMTROL.COM.SG 3|Page
PUBSCA101V2
DIMENSIONAL DRAWING
WWW.COMTROL.COM.SG 4|Page
PUBSCA101V2
INSTALLATION AND MECHANICAL ARRANGEMENT
A. TERMINATIONS AND MOUNTING PROVISIONS
B. INSTALLATION INSTRUCTIONS
1.) Insert the speaker dome into the ceiling cut-out hole, adjust the retaining plates and
tighten the screws to secure the dome.
FIGURE - 1
WWW.COMTROL.COM.SG 5|Page
PUBSCA101V2
2.) Properly connect the speaker cable into the speaker module terminal block. Provide the
cable a slack of around 400 mm for maintenance as shown in figure -1.
3.) Install the speaker module into the dome by sliding-in the spring clips into the catch one
at a time as shown in figure - 2.
FIGURE - 2
WWW.COMTROL.COM.SG 6|Page
PUBSCA-203V2
TECHNICAL MANUAL
HORN SPEAKER, 25WATTS
MODEL: SCA-203
SPECIFICATIONS
Description Weather Proof Horn Speaker
Rated Power Output 25Watts
Input Type 8Ohms or 100Vline
Frequency Response 300 - 13KHz
SPL (1Watt/meter) 103dB
Finish/Color White
Dimension 282(W)x290(D)x210(H)mm
Enclosure Material ABS Enclosure with Metal Bracket
IP Rating IP-66
Weight 2.1 Kg
WWW.COMTROL.COM.SG 1|Page
PUBSCA-203V2
ORDERING INFORMATION
OPTIONS DESCRIPTIONS
/I 8 Ohms Type
/T 100Vline Type (With Transformer)
INSTALLATION AND MECHANICAL ARRANGEMENT
WWW.COMTROL.COM.SG 2|Page
PUBSCA-203V2
(8 OHMS TYPE)
A. TERMINATION POINT AND CABLE ENTRY
C. TERMINATION ARRANGEMENT AND MOUNTING PROVISIONS
WWW.COMTROL.COM.SG 3|Page
PUBSCA-203V2
C. INSTALLATION - PRECAUTIONS
1.) REAR PLASTIC COVER SHOULD BE PROPERLY ATTACHED USING
4 X STAINLESS STEEL SCREWS.
2.) CABLE GLAND SHOULD BE PROPERLY TIGHTENED TO SECURE THE CABLE
AND SEAL THE ENTRY.
3.) SECURE AND TIGHTEN ALL MOUNTING SCREWS OR FASTENERS.
SPEAKER CHARACTERISTIC
WWW.COMTROL.COM.SG 4|Page
PUBSCA-203V2
WWW.COMTROL.COM.SG 5|Page
Outdoor Page and Party Handset Station REVISION - 8
MODEL: IS8025
DESCRIPTIONS
The IS8025 Page & Five-Party handset station is
an industrial grade communication equipment,
designed for use in outdoor safe area
environment. Its simple operation makes it ideal
for mission-critical applications. The tropicalized
PCB modules are installed in a stainless-steel
enclosure.
FEATURES
Universal AC supply (96-264 VAC)
Highly Efficient Class-D Amplifier
Full Duplex Communication
ELECTRICAL CHARACTERISTICS
POWER REQUIREMENTS VALUES
AC Power Supply Input Voltage 96 to 264 VAC (Operating), 50/60 Hz
DC power Supply Input Voltage 24 V dc +/-20%
Minimum Power Input At standby, 10VA
Maximum Power Input At 30 Watts continuous signal, 45VA
HANDSET
Microphone Dynamic, noise-cancelling
Receiver Dynamic, hearing aid compatible
Cord Retractile, 6-foot extended, PVC
Control Press-to-page handset press-bar
HANDSET AMPLIFIER
Audio Level Output 1.5 V (RMS) nominal into 33 load, adjustable (Page and Party)
Distortion Less than 1.50% @ 1K Hz
Audio Frequency Response 250 to 6,500 Hz, +0/-3dB @ 1 KHz
Receiver Level 200 mV (RMS), nominal, Adjustable 150 to 400 mV (RMS)
SPEAKER AMPLIFIER
20 W into 8 with 1.5 V(RMS); default 5 W @ 8
Output Power
Optional: Constant Voltage Output transformer 100/70 VAC
Distortion 1% Maximum @ 20 Watts, 1Khz
Hum and Noise At least 50 dB below rated output
Isolation Input transformers on amplifier input and output
Input Sensitivity Less than 1 Volt for rated output
Input Impedance Greater than 50K
Output Protection Overload/Short-circuit protected
WWW.COMTROL.COM.SG CONTACT: [email protected] 1|P a g e
ENVIRONMENTAL RATINGS
Ingress Protection NEMA:4X, IP65
Temperature Rating NEC, T5
Operating Temperature -30 C to 70 C
MECHANICAL CHARACTERISTICS
Enclosure Dimensions 254 x 410 x 242 (W x L x D, in MM)
Weight 12 Kg
Material Stainless Steel
ORDERING INFORMATION OPTIONS
OPTION DESCRIPTIONS
/RM With Remote System Monitoring
/S Single Party Station
WWW.COMTROL.COM.SG CONTACT: [email protected] 2|P a g e
KX-T7665
The one-line, 16-character display switches to show you either
the caller’s name or telephone number* so you’re ready to provide
good customer service the moment you answer. It also shows the
date and time, call log, call duration, calling extension’s number,
and other useful information.
*To see the caller’s name, the name and number must be registered in the PBX. To
see the caller’s number, you must subscribe to ISDN or an Analogue Caller ID The easy-to-see lamp illuminates to indicate when a call
Service. comes in, so you can tell when the telephone is ringing
even from a distance. It also notifies you that someone
has left a message.
The telephone adjusts Specifications
to either of two angles KX-T7665
for easier use and a LCD Display 1 Line, 16 Characters
smaller, space-saving LCD Contrast 3 Levels
footprint. Programmable CO Keys 8
Conference Yes*
FWD/DND Yes*
Hands-free Speakerphone Yes
Message Yes
These eight keys can be assigned to PBX Auto Answer for ICM Call Yes
Alun functions such as Call Forward(FWD) / Do Not Handset Mute Yes
Disturb (DND), and Conference. Each has a dual- Auto Dial Yes
Lucy
colour LED that shows the line status, extension HOLD Key Yes
Emma
status, on/off, and other information. TRANSFER Key Yes
Bob
Flash/Recall Yes
FWD/DND Last Number Redial Yes
Line3 SP-Phone Volume 12 Levels
Line2 Handset Volume 4 Levels
Whisper OHCA Yes
Line1
Off-Hook Monitor Yes
Paging Receive Yes
Ringing Tone Selection 8 Types
Ringer Volume Control OFF and 4 Levels
Digital XDP Yes
The Digital XDP allows you to increase the number of digital Wall Mount Yes
telephones without the need for additional cards, thus letting you Dimensions 177 x 213 x 107 (Low)
improve your productivity. (W x D x H)(mm) 177 x 201 x 127 (High)
*Digital XDP is only available when you use KX-TDA100/200 Ver.1.1 or later. Weight 0.7 kg
*Can be assigned to the programmable CO keys.
Design and specifications are subject to change without notice. -M63KY-T7665.NE
