M102 DYNA COMP
92503016097revB
M102 DYNA COMP COMPRESSOR
®
DESCRIPTION POWER DIRECTIONS SPECIFICATIONS
• In-line compressor “evens The Dyna Comp is powered by one • Run a cable from your guitar • Rotate OUTPUT knob clockwise Input Impedance 1 MΩ
out” your signal 9-volt battery (remove bottom plate to the Dyna Comp’s INPUT jack to increase overall volume of Output Impedance 10 kΩ
• Especially useful for increased to install), a 9-volt AC adapter such and run another cable from the effect or counterclockwise to Nominal Input Level -5 dBV
sustain with stable dynamics as the Dunlop ECB003/ECB003E, Dyna Comp’s OUTPUT jack to decrease it. Nominal Output Level -12 dBV
or a DC Brick™ power supply. your amplifier. • Rotate SENSITIVITY knob
• Nashville studio standard Noise Floor* 95 dBV
• Start with all controls at clockwise to increase sensitivity
T.H.D 0.2% Typ. at -20 dBV, 1 kHz
12 o’clock. (more compression) or counter-
clockwise to decrease it (less Max Compression 36 dB
• Turn the effect on by depressing
compression). Attack Time 5 ms
the footswitch.
Release Time 1s
Bypass True Hardwire
CONTROLS
Current Draw 3.3 mA
OUTPUT knob controls overall
Power Supply 9 volts DC
effect volume
SENSITIVITY knob sets *A-weighted
compression ratio
FOOTSWITCH toggles effect on/
bypass (red LED indicates on)
SAMPLE SETTINGS
NASHVILLE NEW WAVE SQUASH NASTY
BOTTLENECK
DUNLOP MANUFACTURING, INC.
P.O. BOX 846 BENICIA, CA 94510 U.S.A.
TEL: 1-707-745-2722 FAX: 1-707-745-2658
