TDA7245A

6W AUDIO AMPLIFIER WITH STAND-BY

STAND-BY FUNCTION
SUPPLY VOLTAGE RANGE UP TO 30V
MUSIC POWER = 16W (RL = 4Ω, d = 10%)
THERMAL PROTECTION

DESCRIPTION
The TDA7245A is a monolithic integrated circuit Powerdip 9+9
in 9+9 POWERDIP package, intended for use as
ORDERING NUMBER: TDA7245A
low frequency power amplifier in a wide range of
applications in radio and TV sets.

Figure 1: Test and Application Circuit

May 1997 1/6

TDA7245A

ABSOLUTE MAXIMUM RATINGS

Symbol Parameter Value Unit
VS Supply Voltage 30 V
IO Output Peak Current (non repetitive t = 100µs) 3 A
IO Output Peak Current (repetitive, f > 20Hz) 2.5 A
Power Dissipation at Tamb = 80°C 1 W
Ptot
at T case = 70°C 6 W
Tstg, Tj Storage and junction Temperature -40 to 150 °C

PIN CONNECTION (Top view)

Figure 2: Schematic Diagram

THERMAL DATA
Symbol Description Value Unit
Rth j-case Thermal Resistance junction-case Max 15 °C/W
Rth j-amb Thermal Resistance junction-ambient Max 70 °C/W

2/6
 TDA7245A

ELECTRICAL CHARACTERISTICS (Refer to the test circuit, T amb = 25°C, VS = 16.5V, RL = 4Ω, f =
1kHz; unless otherwise specified).
Symbol Parameter Test Condition Min. Typ. Max. Unit
VS Supply Voltage 12 30 V
VO Quiescent Output Voltage VS = 24V 11.6 V
Id Quiescent Drain Current VS = 28V 24 35 mA
PO Output Power d = 1%
VS = 16.5V, R L = 4Ω 6 W
VS = 20V, R L = 8Ω 5 W
d = 10%
VS = 16.5V, R L = 4Ω 6.5 7.5 W
VS = 20V, R L = 8Ω 6.5 W
Music Power (*)
VS = 24V, d = 10%, RL = 4Ω 16 W
d Harmonic Distortion PO = 50mW to 4W
f = 1KHz 0.15 0.5 %
f = 10KHz 0.8 %

VS = 20V, R L = 8Ω,
PO = 50mW to 3.5W
f = 1KHz 0.12 %
f = 10KHz 0.5 %
RI Input Impedance f = 1kHz 30 KΩ
BW Small signal bandwidth (-3dB) PO = 1W 20 to 40,000 Hz
GV Voltage Gain (open loop) f = 1KHz 75 dB
GV Voltage Gain (closed loop) f = 1KHz 39 40 41 dB
eN Total Input Noise B = 22 - 22,000Hz
R s = 50Ω 1.7 mV
R s = 1kΩ 2 µV
R s = 10kΩ 3 6 µV
S/N Signal to Noise Ratio PO = 5W; RS = 10KΩ 86 dB
SVR Supply Voltage Rejection VS = 16.5V; R L = 8Ω; f = 100Hz 38 45 dB
R s = 10kΩ; Vr = 0.5Vrms
T sd Thermal shut-down Junction 150 °C
Temperature

STAND-BY FUNCTION
Symbol Parameter Test Condition Min. Typ. Max. Unit
Vst-by Pin 5 DC Voltage SW1 Open (play) 6.4 V
Ist- by Pin 5 Current SW1 Closed (st-by) 160 280 µA
ATT st-by Stand-by Attenuation f = 1kHz 70 90 dB
Vt Stand-by Threshold (pin 5) 3.8 V
Id st-by Quiescent Current @ Stand-by 2 4 mA

Note (*):

MUSIC POWER CONCEPT

MUSIC POWER is ( according to the IEC clauses n.268-3 of Jan 83) the maximal power which the amplifier is capable of producing across the
rated load resistance (regardless of non linearity) 1 sec after the application of a sinusoidal input signal of frequency 1KHz.

According to this definition our method of measurement comprises the following steps:
1) Set the voltage supply at the maximum operating value -20%
2) Apply a input signal in the form of a 1KHz tone burst of 1 sec duration; the repetition period of the signal pulses is > 60 sec
3) The output voltage is measured 1 sec from the start of the pulse
4) Increase the input voltage until the output signal show a THD = 10%
5) The music power is then V2out/R1, where Vout is the output voltage measured in the condition of point 4) and R1 is the rated load impedance

The target of this method is to avoid excessive dissipation in the amplifier.

3/6
TDA7245A

Figure 3: Output Power vs. Supply Voltage Figure 4: Output Power vs. Supply Voltage

4/6
 TDA7245A

POWERDIP 18 PACKAGE MECHANICAL DATA

mm inch
DIM.
MIN. TYP. MAX. MIN. TYP. MAX.

a1 0.51 0.020

B 0.85 1.40 0.033 0.055

b 0.50 0.020

b1 0.38 0.50 0.015 0.020

D 24.80 0.976

E 8.80 0.346

e 2.54 0.100

e3 20.32 0.800

F 7.10 0.280

I 5.10 0.201

L 3.30 0.130

Z 2.54 0.100

5/6
TDA7245A

Information furnished is believed to be accurate and reliable. However, SGS-THOMSON Microelectronics assumes no responsibility for the
consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No
license is granted by implication or otherwise under any patent or patent rights of SGS-THOMSON Microelectronics. Specification mentioned
in this publication are subject to change without notice. This publication supersedes and replaces all information previously supplied. SGS-
THOMSON Microelectronics products are not authorized for use as critical components in life support devices or systems without express
written approval of SGS-THOMSON Microelectronics.
 1997 SGS-THOMSON Microelectronics – Printed in Italy – All Rights Reserved
SGS-THOMSON Microelectronics GROUP OF COMPANIES
Australia - Brazil - Canada - China - France - Germany - Hong Kong - Italy - Japan - Korea - Malaysia - Malta - Morocco - The Netherlands -
Singapore - Spain - Sweden - Switzerland - Taiwan - Thailand - United Kingdom - U.S.A.

6/6
This datasheet has been download from:

www.datasheetcatalog.com

Datasheets for electronics components.