WW piezometers convert water pressure on the diaphragm to be measured into an equivalent frequency signal. The pressure on the diaphragm changed by fluid pressure ‘causes a change in tension of the wire. The wire excited by the plucking vibrates at its resonant frequency. The frequency signal transmitted through a cable to the readout. ‘Special stainless steel is used to minimize thermal zero shift in the frequency and the precision of the diaphragm is, high when manufactured it. Also the pressure transducer is equipped with a lightning protection for protecting the sensor electrical shock and a. temperature device for compensating for temperature variations. © Not affected by cable length and resistance change, reproducibility are very excellence © Optimum design © Possible to automatic measurement (Unit: m) 0.0 |198)926 | 9329254 \925.4,9254,0175| B12.7 451 | 1695) 219 |1695| 151 Geotechnical & Structural Instrumentation eo ‘The VW piezometers are designed to measure pore water, and fluid pressure at the pressure tank and pipe line, borehole, foundation, and dam, ‘© Measurement ofthe effects of drainage systems used for excavations. © Measurement of pore water pressure to determine safety factor under excavation or banking, © Measurement of water level to check the performance in rivers, reservoirs, standpipes, © Measurement of pore water pressure to determine slope stabilty ‘© Measurement of flows of underground water and water leakage in embankments, dams and artificial lakes. [Model 1510 standard] Model 1510 VW piezometer is designed to be embedded in earth fills and at concrete interfaces or inserted into, boreholes and small diameter pipes. [Model 1520 push-in type] Mode! 1520 VW piezometer is placed in consolidated fine {grain materials such as sand, sil, or clay. ‘The extemal housing is a thick walled cylinder fited with tapered shoe at one end, and an EW drill rod or standard, pipe thread adapter at the cable entry end, It can withdraw to use again after construction. [Model 1530 pressure sensor type] Model 1530 VW piezometer is designed to measure fluid pressure in pipelines for industrial and hydraulic. Model 1830 was processed as 3/8" pipe thread, so you can itectly unite to the female thread part or you can unite to the male thread part using the union. And it is useful to measure up stream pressure in a hydroelectric power plant. F2 Tel: 82-31-459-8753/7 + Fax 82-31-459-8758 + Website: www aceinstrument.com / www.aceco kr + E-mail: acens@naver com[Model 1540 heavy duty typo] This model is specially manufactured to use in the site winere semi permanent measurement is necessary lke dam site, PU sheath cable with aramid fiber and diameter of 07 is adopted [Model 1545 ring filter type] This model is equipped with a ring type large metal filter. ‘The rng ype fer has avery wise contract surace and can be Used for all part such as seawater, sand layer, sediment layer, mineral layer. Iean use as water level sensor as wel [Model 1515 low pressure type] ‘This model is designed to measure low pressure. There are three varieties of measuring range as 1.0/1.5/2 0kglor. For measuring water pressure, [Model 15008 slim type] This model is made into small size(OD 17.5m) for measuring at IDG 19an standpipe. Geotechnical & Structural Instrumentation [Model 1500US ultra slim type] This model is made into small size (OD 12.7 nn) GZ A” _ fiers Itis connected to the system such as the VW readout units, data loggers to be data logging and data acquisition system to monitor readings. It is compatible with other company’s readout unt. + ACE-800 (VW readout) + ACE-1000 (VW data recorder) + ACE-1100 series (VW mini logger) + ADL-200 / ARF-100 (Smart logger / Smart controler) eee ‘© VW piezometers are sensitive to atmospheric pressure variations. The change in heads caused by atmospheric pressure variations, must be compensated for them, Using @ barometer to take an accurate reading in field that atmospheric pressure variations is frequent as dams, valleys and reclaimed lands. ‘© VW piezometer is attached with low density filter of 50, 1m, Soak it into water over 12hours before establishment and deflate air, then you can get accurate measurement. © In establishing VW piezometer, please, put signal cable longer enough than depth of perforation by 10~-20% so as to prevent from breakdown of cable by settlement. ‘© A high air entry tip with 1 micron pores and permeability is used in unsaturated soils and where negative pore pressures are anticipated. ‘© When you install VW piezometer in soft ground, you must protect a signal cable by garden hose. If not, the signal cable is cut down ar is short circuit caused by rotation of drill core, F2 ‘Tel :82-31-459-8753/7 + Fax: 82-31-059-8758 * website: wwwwaceinstrument.com / waw.aceco.kr + Ema SeeGeotechnical & Structural Instrumentation Sensor elerert iran wire sensor Range 3.5-70kglcr pee |e Fesciton 025% FER ‘Accuracy “£0.1% FSR Nonineariy 405% FSR ‘Over range capacity 150% FSR “Therral zoo shit Less than 0.08% FSR “Operating temperature | -40-80%C Builtin temperature device __| Thetmistor (3k0) Temperature device range | -40~105°C Temperature device accuracy | +0.5°C Waterproof 41000m H:O Materials Stainless steel. high grade epoxy resin potting GS ‘Standard : 50 micron sintered stainless fiter/ air transit pressure : about 5.6kgla Optional : 1 micron / 100 micron ceramic fiter Buitin lightning protection | Gas tube arrester (frequency output lines) ‘Weight 02kg | 0.8kg [03kg | OSkg | O5kg | O2kg | O.tkg | Oka G6 4nn, 0.37m x4C shielded PU sheath cable Signal cable (For 1840 : 7am, 0:44mX4C On Aramis fiber reinforced PU sheath cable) (Note) The accuracy depends on air entry in the fiter, compensating thermal zero shift and difference in air pressure. ttcan be manufactured in STS316 material for use in seawater according to customer request. There may be a negative pressure zone in civil engineering sites. Our company is equipped with negative pressure calibration facilty and will make a second calibration by -1kglor if requested. Crm mente SE ee ‘© Model number © Universal terminal box (mode! 701217024) © Applicaton ld «© Polyethylene sheath cable for heavy duty © Pressure range © EW adaptor (for 1520) © Keeping VW readout unit © EW coupling (for 1520) ‘© Cable length «© Protective cover (PC-40) © Negative pressure exist or not in installation field © Barometer © 200kg/ox? special order for the product that is not in catalogue is possible FQ 1 Tel:82-31-459-8753/7 «Fax 82-31-459-8758 + Website: www aceinstrument.com / www.aceco kr + E-mail [email protected]