Scribd
Upload
312 views6 pages

Creating Extrusion in A Door or Window Revit

To create an extrusion trim around a door or window in Revit: 1) Set the family category to Casework 2) Name the family Door Trim 3) Draw the trim profile by offsetting lines from the door/window frame edge and connecting below 4) Extrude the profile along the wall plane to the specified offset distance

Uploaded by

Amer Gonzales
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
312 views6 pages

Creating Extrusion in A Door or Window Revit

To create an extrusion trim around a door or window in Revit: 1) Set the family category to Casework 2) Name the family Door Trim 3) Draw the trim profile by offsetting lines from the door/window frame edge and connecting below 4) Extrude the profile along the wall plane to the specified offset distance

Uploaded by

Amer Gonzales
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 6

CREATING EXTRUSION IN A DOOR OR WINDOW

1) Architecture-Component-Model in Place

2) Family Category-Casework then click OK

3) Name it Door Trim then click ok


4) Click Extrusion

5) Pick a Plane then click OK


6) Click Wall as the Plane

7) Click the edge of the wall and pick lines and offset.
8) Specify the offset distance
9) Click the door frame edge to offset & close the lines below door.

10) Specify extrusion start and end then click apply.

11) Click Material Category.


12) Choose the material in the browser then click ok then finish mode.

13) Then click Finish model


14) Done

You might also like