Scribd
Upload
309 views6 pages

Remove & Install MPC Processor

The document provides instructions for removing and installing an MPC processor. It involves placing the ECU on a soldering station and setting the temperature to 160, 180, and 215 degrees Celsius to clean it. Soldering paste is applied to the MPC and BGA chips before placing it on a reballing station to refill solder balls into the holes. Excess solder balls are removed and the chips are inspected. The MPC is then aligned and heated on the soldering station at 165 and 200 degrees Celsius to complete the installation.

Uploaded by

SzekelyGobe
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
309 views6 pages

Remove & Install MPC Processor

The document provides instructions for removing and installing an MPC processor. It involves placing the ECU on a soldering station and setting the temperature to 160, 180, and 215 degrees Celsius to clean it. Soldering paste is applied to the MPC and BGA chips before placing it on a reballing station to refill solder balls into the holes. Excess solder balls are removed and the chips are inspected. The MPC is then aligned and heated on the soldering station at 165 and 200 degrees Celsius to complete the installation.

Uploaded by

SzekelyGobe
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 6

Remove & Install MPC Processor

Place the ECU on the Soldering Station

Step 1: Set Temperature to 160ºC

Step 2: Set Temperature to 180ºC

Website: www.mbstuning.com Email: [email protected]


Step 3: Set Temperature to 215ºC

Clean up the MPC Processor

Apply Soldering Paste on the MPC


Website: www.mbstuning.com Email: [email protected]
Place the MPC on the reballing station

Select the appropriate steel mesh according to chip type. Fix


the steel mesh to the ceiling cover and tighten it with 4 M3 screws

Put the solder ball, clench hands and gently swaying reballing station to
ensure the solder ball completely filled in the holes.

Website: www.mbstuning.com Email: [email protected]


Pour out extra solder balls

Remove the lid, carefully scored BGA chips. Observe the chip, if individual
solder balls are not in the hole rightly, please correct it with forceps.

Website: www.mbstuning.com Email: [email protected]


Heat solders balls on the BGA to soldering it on BGA

Remove solder from ECU

Clean up the ECU

Apply solder paste

Website: www.mbstuning.com Email: [email protected]


Align the MPC properly

Heat up with soldering station

Step 1: Set Temperature to 165ºC Step 2: Set Temperature to 200ºC

Website: www.mbstuning.com Email: [email protected]

You might also like