How To Flash Stock ROM Firmware On Your Device: Download Samsung Galaxy J2 Prime SM-G532M USB Driver
Uploaded by
learmonthHow To Flash Stock ROM Firmware On Your Device: Download Samsung Galaxy J2 Prime SM-G532M USB Driver
Uploaded by
learmonthHow To Flash Stock ROM Firmware On Your Device
Step 1: To get started, download Samsung Galaxy J2 Prime SM-G532M USB driver and install it in
your computer. Once done, download the stock firmware of your device and extract the zip file to get
the “.tar.md5” file as shown below.
Step 2: Next, switch off your smartphone. Once done, boot it into the “Download” mode by pressing
and holding the Volume Down, Power and Home buttons simultaneously. Now your Samsung device
will vibrate. Once you have felt it, keep pressing the Volume Down and Home buttons (leave the
Power button) and your device will boot into the Download mode.
Step 3: Now you will see a “Warning” message as shown below. Just press the “Volume Up” key to
continue.
Step 4: Next, download Odin and extract it to a folder in your computer. Once done, click on
“Odin3.exe” to launch its window.
Step 5: Now connect your smartphone to the computer using the original USB data cable. If you have
installed the USB drivers of your device properly in the Windows computer, Odin will automatically
identify your device and will show a “Added” message in the “Log” section.
Step 6: Next, click on the “AP” button and select the “.tar.md5” file (from Step 1).
Step 7: Once the Samsung firmware file is added, click on “Start” button in “Odin” to launch the
flashing process.
Step 8: Don’t do anything during the flashing process. Once it gets completed, you will see the green
“PASS” message as shown in the screenshot below.
Step 9: Now unplug your device from the computer. But when you try to boot your device normally, it
will get into a boot loop. To fix this error, switch off your smartphone and boot into the “Recovery”
mode by pressing and holding the Volume Up, Power and Home buttons simultaneously.
Step 10: Once your device boots into the recovery mode, click on “Wipe data/factory reset“. Once
done, click on “Reboot System Now” as shown in the screenshot below.
That’s it. Now you have successfully flashed Stock ROM firmware on your Samsung Galaxy J2
Prime SM-G532M Android device. If you encounter any issues while following this tutorial, do let
me know via comments
