JoPPS User Manual V6.0
JoPPS User Manual V6.0
Nov.2018
V 6.0
JoPPS User Manual
Copyright©JOUAV
JoPPS User Manual
Steps:
① Select the path and project name.
② Select base data, which should be downloaded from GCS-202.
③ Select rover data, which should be downloaded from PPS module of aircraft.
④ Select photo data, which should be downloaded from CWCommander.
⑤ Select GPS-Camera postion. Here are some standard payload parameters.
CW-007:
Airframe antenna: X = -0.294, Y = 0, Z = -0.092
Tail antenna: X = -1.031, Y = 0, Z = -0.199
CW-10: X = -0.794, Y = 0.01, Z = -0.4975
CW-20: X = -0.66, Y = 0, Z = 0.06
⑥ Choose the unit, and input the slant height.The slant height should be
measured as below picture.
⑦ Input the coordinate of GCS-202, with WGS84 format and ellipsoidal height.
⑧ If choose “CGCS2000 Result”,there would be a CGCS2000 data after
processing, or just get WGS84 data.
Copyright©JOUAV
JoPPS User Manual
3. Click “OK” and start, the software will run and process automatically.
4. After processing, we will get the result as the picture.Higher fix percent, higher
data quality.
Copyright©JOUAV
JoPPS User Manual
Copyright©JOUAV
JoPPS User Manual
Appendix
1. CGCS2000
North East Ellipsoidal Magnetic GPS Groud Photo Accurate Status
SN Time Roll Pitch Millisecond
Coordinate Coordinate Height Heading Heading Speed Name Time (1 is fix)
Copyright©JOUAV
JoPPS User Manual
2. WGS84
Copyright©JOUAV