Technical data sheet TR24-SR

Rotary actuator for ball valves

• Torque motor 2 Nm
• Nominal voltage AC/DC 24 V
• Control modulating 2...10 V

Technical data
Electrical data Nominal voltage AC/DC 24 V
Nominal voltage frequency 50/60 Hz
Nominal voltage range AC 19.2...28.8 V / DC 21.6...28.8 V
Power consumption in operation 0.5 W
Power consumption for wire sizing 1 VA
Connection supply / control Cable 1 m, 3 x 0.75 mm²
Parallel operation Yes (note the performance data)
Functional data Torque motor 2 Nm
Operating range Y 2...10 V
Input Impedance 100 kΩ
Manual override with hand crank
Running time motor 90 s / 90°
Sound power level, motor 35 dB(A)
Position indication Mechanical
Safety Protection class IEC/EN III Safety Extra-Low Voltage (SELV)
Degree of protection IEC/EN IP40
EMC CE according to 2014/30/EU
Certification IEC/EN IEC/EN 60730-1 and IEC/EN 60730-2-14
Mode of operation Type 1
Rated impulse voltage supply / control 0.8 kV
Control pollution degree 3
Ambient temperature -7...50°C
Storage temperature -40...80°C
Ambient humidity Max. 95% r.H., non-condensing
Servicing maintenance-free
Weight Weight 1.1 kg

www.belimo.com TR24-SR • en-gb • 2019-11-27 • subject to changes 1

 Rotary actuator, modulating, AC/DC 24 V, 2 Nm
TR24-SR

Safety notes
• This device has been designed for use in stationary heating, ventilation and air-

! conditioning systems and must not be used outside the specified field of application,
especially in aircraft or in any other airborne means of transport.
• Outdoor application: only possible in case that no (sea) water, snow, ice, insolation
or aggressive gases interfere directly with the actuator and that is ensured that the
ambient conditions remain at any time within the thresholds according to the data
sheet.
• Only authorised specialists may carry out installation. All applicable legal or
institutional installation regulations must be complied during installation.
• The device may only be opened at the manufacturer’s site. It does not contain any
parts that can be replaced or repaired by the user.
• The device contains electrical and electronic components and must not be disposed
of as household refuse. All locally valid regulations and requirements must be
observed.
• The switch for changing the direction of rotation may only be operated by authorised
specialists. The direction of rotation must not in particular be reversed in a frost
protection circuit.

Product features
Mode of operation The actuator is connected with a standard modulating signal of 0...10 V and drives to
the position defined by the positioning signal.
Simple direct mounting Simple direct mounting on the ball valve with only one screw. The mounting orientation
in relation to the ball valve can be selected in 90° steps.
Manual override Manual override possible with lever (the gearing is disengaged as long as the self-
resetting lever is pressed).
High functional reliability The actuator is overload protected and automatically stops when the end stop is
reached.
The actuator switches off for seven seconds in the case of blocking, then attempts to
restart. If the blocked condition persists, the actuator attempts to restart once every
two minutes a total of 15 times and subsequently only once every two hours.
Combination valve/actuator Refer to the valve documentation for suitable valves, their permitted fluid temperatures
and closing pressures.

Electrical installation

Notes • Connection via safety isolating transformer.

! • Parallel connection of other actuators possible. Observe the performance data.

Wiring diagrams

AC/DC 24 V, modulating
T ~
– +

Y DC (0)2...10 V

Cable colours:
1 = black
1 2 3 2 = red
3 = white
R 123

Direction of rotation R (standard)

when switch set to right position

2 TR24-SR • en-gb • 2019-11-27 • subject to changes www.belimo.com

 Rotary actuator, modulating, AC/DC 24 V, 2 Nm
TR24-SR

Electrical installation
AC/DC 24 V, modulating, override control
T ~
– +
Y DC (0)2...10 V
c d

1 2 3

c d Y1 / Y2 Cable colours:
Y1 A – AB = 100% 1 = black
Y2 A – AB = 0% 2 = red
DC (0)2...10 V 3 = white

Dimensions [mm]
Dimensional drawings

67
69
78

55

22
84

Further documentation
• The complete product range for water applications
• Data sheets for ball valves
• Installation instructions for actuators and/or ball valves
• General notes for project planning

www.belimo.com TR24-SR • en-gb • 2019-11-27 • subject to changes 3