Scribd
Upload
99 views7 pages

Drill: Cv. Shuuken Precision Toolsindo

This document discusses important aspects of drill sharpening including point angle, chisel edge angle, helix angle, and total clearance. It provides tables with recommended point angles for different materials as well as helix angles for various drill diameters and material types. Tool tolerances for drill diameter are also specified with allowable upper and lower bounds.

Uploaded by

Erizal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
99 views7 pages

Drill: Cv. Shuuken Precision Toolsindo

This document discusses important aspects of drill sharpening including point angle, chisel edge angle, helix angle, and total clearance. It provides tables with recommended point angles for different materials as well as helix angles for various drill diameters and material types. Tool tolerances for drill diameter are also specified with allowable upper and lower bounds.

Uploaded by

Erizal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 7

CV.

SHUUKEN PRECISION TOOLSINDO

DRILL
BAGIAN-BAGIAN DRILL
HAL-HAL PENTING DALAM PENGASAHAN DRILL

Point Angle (Sudut depan)

Chisel Edge Angle

Helix Angle

Total Clearance
 POINT ANGLE (SUDUT DEPAN)
 Untuk standart drill sudut depan ( Point Angle ) adalah 118 
 Tabel I Point Angle menurut FMS
 Tabel II Point Angle menurut Production Technology
TABEL I
Jenis Material Point Angle
Carbon Steel, Low Alloy Steel 130 
High Alloy Steel ( Hardening Steel ) 140 
Comon Cast Iron ( Sampai FC 200 ) 120 
High Cast Iron , Alloy Cast Iron 130 
Logam Non Besi 120 
Aluminium 130 
TABEL II
JENIS MATERIAL POINT ANGLE
Steel & Cast Iron 118 
Stainless Steel 140 
Austenitic Steel 140 
Cast Iron 118 
Malleable Cast Iron 118 
Brass 118 
Copper 140 
Aluminium alloys short & long chip type 140 
Magnesium alloys 140 
Nickel 118 
Zinc alloys 118 
Moulded plastics 80 
Laminated plastics 80 
Celluoid 140 
Hard rubber &thin plastic material 80 
Marble, slate & carbon 80 
 CHISEL EDGE ANGLE
 HELIX ANGLE

Diameter Recommended Helix Angle


over Up To Normal Hard & Brittle Soft Material
Material Material
- 0.6 16 3 - -
0.6 1.0 18 3 - -
1.0 3.2 20 3 10  2 35 5
3.2 5.0 22 3 12  3 35 5
5.0 10. 25 3 13  3 40 5
10.0 - 30 3 13  3 40 5
 TOTAL CLEARANCE

o Tooleransi untuk diameter drill

Diameter Batas Toleransi


Dari Sampai Atas Bawah
- 3 0 0.014
3 6 0 0.018
6 10 0 0.022
10 18 0 0.027
18 30 0 0.033
30 50 0 0.039
50 80 0 0.046

You might also like