Scribd
Upload
115 views1 page

TOPIx - WSM-7811 - Workshop Manual Freelander 2 2007-10 - 4 - Golire Si Umplere HALDEX

The document provides instructions for filling the active on-demand coupling in a Freelander 2 from 2007-2010. It states to fill it with 650 ml of fluid and notes that it is not possible to fully drain it during service. The procedure involves raising the vehicle, collecting any spilled fluid, removing the filler plug and filling it until fluid runs from the hole, running the ignition for 5 minutes, then removing exactly 70 ml of fluid with a syringe before replacing the plug.

Uploaded by

Bernardo Ramirez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
115 views1 page

TOPIx - WSM-7811 - Workshop Manual Freelander 2 2007-10 - 4 - Golire Si Umplere HALDEX

The document provides instructions for filling the active on-demand coupling in a Freelander 2 from 2007-2010. It states to fill it with 650 ml of fluid and notes that it is not possible to fully drain it during service. The procedure involves raising the vehicle, collecting any spilled fluid, removing the filler plug and filling it until fluid runs from the hole, running the ignition for 5 minutes, then removing exactly 70 ml of fluid with a syringe before replacing the plug.

Uploaded by

Bernardo Ramirez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

10/9/13 TOPIx - WSM-7811 - Workshop manual Freelander 2 2007-10

Published: 11-May-2011
Rear Drive Axle/Differential - Active On-Demand Coupling Filling
General Procedures

NOTE: If installing a new active on-demand coupling, fill with 650 ml of fluid. It is not possible to completely
drain the active on-demand coupling fluid during service. The procedure below MUST be followed for both filling
and topping up.

1. C AUTION: Make sure the vehicle is on a flat level


surface.

Raise and support the vehicle.

2. No provision is made to fully drain the active on-demand


coupling. During repair procedures, fluid will be lost. A
container should be positioned to collect any spillage.

3. C AUTION: This is a filler plug only and must


not be used as a fluid level indicator.

Make sure the vehicle is level. Remove the filler


plug and discard the sealing washer.

4. Fill the active on-demand coupling, until a thin thread of fluid


runs from the filler hole.

Refer to: Specifications (205-02 Rear Drive Axle/Differential,


Specifications).

5. Install the active on-demand fluid filler plug.

6. Turn the ignition on for 5 minutes.

7. Turn the ignition off and remove the remote handset.

8. Fill the active on-demand coupling, until a thin thread of fluid


runs from the filler hole.

9. C AUTION: This is a filler plug only and must not be used


as a fluid level indicator.

Using a syringe, remove exactly 70 ml of fluid.

10. C AUTION: Replace the washer.

Install and tighten the filler plug.

Torque: 35 Nm

https://topix.landrover.jlrext.com/topix/content/document/view?id=146634&groupId=276 1/1

You might also like