Scribd
Upload
57 views1 page

Motores Sumergibles Grundfos Sand Solution

The document describes the Grundfos 6" GSS motor, which features a SIC/SIC mechanical shaft seal to handle sandy well applications. It has an all stainless steel exterior construction, stainless steel spline shaft, and hermetically encapsulated stator windings. The motor is rated up to 104 degrees F with 0.5 feet/second flow and includes components like a sand slinger, pressure equalization diaphragm, and epoxy coated bearing support. Construction materials include a SIC/SIC seal, 304 stainless steel for the stator and end bells, and 316 stainless steel for the shaft and filter.

Uploaded by

alejandro obregon
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
57 views1 page

Motores Sumergibles Grundfos Sand Solution

The document describes the Grundfos 6" GSS motor, which features a SIC/SIC mechanical shaft seal to handle sandy well applications. It has an all stainless steel exterior construction, stainless steel spline shaft, and hermetically encapsulated stator windings. The motor is rated up to 104 degrees F with 0.5 feet/second flow and includes components like a sand slinger, pressure equalization diaphragm, and epoxy coated bearing support. Construction materials include a SIC/SIC seal, 304 stainless steel for the stator and end bells, and 316 stainless steel for the shaft and filter.

Uploaded by

alejandro obregon
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

GRUNDFOS 6” GSS MOTOR

Grundfos Sand Solution


with a SIC/SIC seal to handle sandy well applications

GSS Features and Benefits


• SIC/SIC Mechanical Shaft Seal
• Range of motors from 7.5 - 40HP 3PH
• Corrosion Resistant All Stainless Steel Exterior Construction
• Stainless Steel Spline Shaft
• Stator Windings Hermetically Encapsulated in Stainless Steel
• Water Lubricated
• Internal Water Circulation System Enhances Motor Cooling
• Rated up to 104 Degrees F with .5 ft./sec. Flow Past Motor
• Michell Type Carbon/Ceramic Thrust Bearing
• Pressure Equalization Diaphragm
• Sand Slinger
• Epoxy Coated Bearing Support
• Equipped with Tempcon Temperature Sensor as Standard
• Works with MTP 75 and CU3 Motor Protection System
• Replaceable Motor Lead
• NEMA Mounting Dimensions

Construction Material Specification

Seal SIC/SIC Mechanical Seal


Stator 304 SS
End Bells 304SS
Seal Retainer 304SS
Diaphragm NBR rubber
Sand Slinger NBR rubber
Lead PUR
Filter 316SS
Cable Neoprene *12 month warranty comes standard
Shaft 316SS with purchase of a GSS motor.

You might also like