Scribd
Upload
102 views2 pages

4E1 To Ethernet Protocol Converter

The document describes a 4E1 to Ethernet protocol converter that uses inverse multiplexing technology to transfer data across 4 E1 channels and Ethernet interfaces. It has features such as VLAN support, delay detection, automatic fault recovery, and meets various telecom standards.

Uploaded by

James Omara
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
102 views2 pages

4E1 To Ethernet Protocol Converter

The document describes a 4E1 to Ethernet protocol converter that uses inverse multiplexing technology to transfer data across 4 E1 channels and Ethernet interfaces. It has features such as VLAN support, delay detection, automatic fault recovery, and meets various telecom standards.

Uploaded by

James Omara
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

4E1 to Ethernet protocol converter

4E1 to Ethernet protocol converter IDM-4E1/ETH is protocol converter use inverse multiplexing
technology. IDM-4E1/4ETH net can make many channel E1 transfer 10M/100M Ethernet. it can make
4E1 channel and Ethernet interface interconversion. The max Ethernet bandwidth is 7.92M.  IDM-
4E1/4ETH protocol converter is used in LAN-To-LAN, Bureau of the interconnect , VOD, remote control,
Switches of E1 interface card etc. it  expand the transmission distance and applied range with the many
E1 resource in telecommunication network.

Feature

  Standard 19 inch 1U housing structure, easy install.

  4 Ethernet and 4 E1 inverse multiplexing, Support TAG VLAN setting

  Support E1 channel delay detection function, The max relative delay in E1 channel is 220ms

  Can transfer jumbo frame, support Ethernet switchboard with Vlan faction.

  Can delete the faulted E1 channel automatic. it can automatic recover when the faulted is deleted

  Support RS232 interface and SNMP webmaster

  Support GFP-F, meet ITU-T G.7041 standard.

  Support 2M line loopback function

  Can transparent transmission Jumbo Frame that meet IEEE 802.1Q, support Ethernet converter with
VLAN function

Specification:
E1 interface

Code pattern HBD3 Code rate 2048Kbps±50ppm


Impedance 70Ω / 120Ω frame structure PCM31/30
JITTER standard ITU-T G.823 Standard Protocol ITU-T G.703/G.704
pattern Can set Framing or not Framing, Time slot can match

Ethernet interface

interface type RJ45 Rate 10M/100M


Standard Protocol IEEE802.3 Working mode Full/Half duplex

Power supply

Power supply AC220V/DC-48V power consumption ≤5W

Environmental conditions

Work Temperature 15ºC~65ºC storage temperature -25ºC~75ºC


Humidity 0- 95% (non-congelation state)

Application

Product model:

type Describe
IDM E1-ETH Ethernet to 1group E1 GF protocol conversion, offer 1group balance and unbalance E1
interface.
IDM 4E1-ETH Ethernet to 4group E1 GF protocol conversion, offer 4group balance and unbalance E1
interface.
IDM 8E1-ETH Ethernet to 8group E1 GF protocol conversion, offer 8group balance and unbalance E1
interface.

You might also like