Scribd
Upload
131 views6 pages

Seismic Analysis

This document outlines the design basis and calculations for seismic analysis of a structure. It provides key parameters like occupancy category, soil type, seismic zone, time period, design base shear, and minimum and maximum base shears. It then calculates the vertical distribution of seismic forces at different levels of the structure using the total weight and height. Finally, it lists outputs from STAAD analysis like reactions, axial forces, bending moments and shear forces.

Uploaded by

Sharah Quilario
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
131 views6 pages

Seismic Analysis

This document outlines the design basis and calculations for seismic analysis of a structure. It provides key parameters like occupancy category, soil type, seismic zone, time period, design base shear, and minimum and maximum base shears. It then calculates the vertical distribution of seismic forces at different levels of the structure using the total weight and height. Finally, it lists outputs from STAAD analysis like reactions, axial forces, bending moments and shear forces.

Uploaded by

Sharah Quilario
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 6

I.

BASIS FOR DESIGN

Occupancy Categories I = 1.00 NSCP 2015 Table 208-1


Soil Profile Type = SD NSCP 2015 Table 208-2
Zone z = 0.40 NSCP 2015 Table 208-3
Seismic Source Type = A NSCP 2015 Table 208-4
Near Source Factor Na = 1.00 NSCP 2015 Table 208-5
Nv = 1.20 NSCP 2015 Table 208-6
Seismic Coefficient Factor Ca = 0.44 NSCP 2015 Table 208-7
Cv = 0.77 NSCP 2015 Table 208-8
Response Reduction Factor R = 8.00 NSCP 2015 Table 208-11
Total Weight of Structure W = 58.86 kN

II. STRUCTURE PERIOD

Time Coefficient Ct = 0.0853 NSCP 2015 208.5.2.2


Total Height of Structure hn = 6.30 m
Time Period T = 0.34 s

III. STRUCTURE PERIOD

Design Base Shear V = Cv I W


RT
= 16.66 kN
Maximum Base Shear Vmax = 2.5 Ca I W
R
= 8.09 kN
Minimum Base Shear Vmin = 0.11 Ca I W
= 2.85 kN
Vmin = 0.8 Z Nv I W For Zone 4 only
R
= 2.83 kN

Since Vmin < V > Vmax Use 8.09 kN


IV. VERTICAL DISTRIBUTION OF FORCE

Force at the top of the Structure Ft = 0.07 T V


= 0.19 kN
Since T < 0.70 s Use 0.00 kN

Wx hx Fx
Level Wx hx
kN m kN

Ground 0.00 0.00 0.00 0


2nd 9.81 2.10 20.60 0.578
3rd 19.62 4.20 82.40 2.312
4th 29.43 6.30 185.41 5.203

TOTAL 58.86 288.41

V. STAAD REPORTS

Reactions
Axial Forces
Maximum Bending Moments
Maximum Shear Forces
STAAD MODEL

You might also like