Scribd
Upload
404 views1 page

Crane Operator Daily Checklist

1) The document is a standard tower crane start of shift inspection checklist that lists 27 inspection items to check on the crane. 2) It requires the operator and supervisor to sign off weekly indicating the inspections have been completed. 3) Inspection items include checking the electrical power cords, ground fault circuit interrupter, controls, brakes, load block/hook, and that all audio/visual indicators are functioning properly.

Uploaded by

Mohamed Moustafa Elashwah
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
404 views1 page

Crane Operator Daily Checklist

1) The document is a standard tower crane start of shift inspection checklist that lists 27 inspection items to check on the crane. 2) It requires the operator and supervisor to sign off weekly indicating the inspections have been completed. 3) Inspection items include checking the electrical power cords, ground fault circuit interrupter, controls, brakes, load block/hook, and that all audio/visual indicators are functioning properly.

Uploaded by

Mohamed Moustafa Elashwah
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

STANDARD TOWER CRANE “START OF SHIFT INSPECTION”

Lessee: ________________________________________ Week of: ________________________ Year: _____________

Project: ______________________________________________ Crane Owner: ____________________________________________

Site Address: ___________________________________________________________________________________________________

Crane Make: ________________________ Model: ____________________ Serial #: ________________________________________

; Checked, approved, and in good working order ⊠ Checked, found faulty, notified supervisor
(details required under remarks) ⊟ Not applicable to this item

# Standard Tower Crane Operator Sun Mon Tue Wed Thu Fri Sat
1 Electrical power cords – main feed – junction box/splice
2 Ground fault circuit interrupter (GFCI)
3 ON/OFF switch (main disconnect)
4 Crane base inspection
5 Inspect walkways, handrails, guards, ladders, and perimeter barricade
6 Inspect structure, pins, keepers, and mast bolts
7 Ensure all tower wedges or tie backs are in place and tight
8 Ensure all doors, panels, and covers are in place and weather-tight
9 Operators controls functioning adequately
10 Load moment hoist limit
11 Load moment trolley limit
12 Maximum load (line pull)
13 Trolley out
14 Trolley in
15 Hoist up deceleration limit
16 Hoist upper limit
17 Hoist down limit or slack line
18 Ensure all audio/visual indicators are functioning properly
19 Anemometer
20 Hoist brake is functioning
21 Slewing brake is functioning
22 Trolley brake
23 Visually inspect load block and hook
24 Travel brake to rail where applicable
25 Rail travel forward and reverse operation and limit
26 Inspect tracks for loose connections, proper drainage, subsidence and
bogie wear on travelling cranes, rail clamps, and end stops
27 Housekeeping:
concrete debris, rebar dowels, signage lights, access/egress, etc.
28 Supervisor notified of defects or faults

29 Operator to initial daily

Remarks:_____________________________________________________________________________________________
____________________________________________________________________________________________________
____________________________________________________________________________________________________
____________________________________________________________________________________________________
____________________________________________________________________________________________________

Weekly Supervisor and Operator signatures indicating inspections have been completed

Operator’s Signature: __________________________ Operator’s Name:_________________________ Certificate No. _______________


PRINT
Supervisor’s Signature:__________________________________ Supervisor’s Name: __________________________________________
PRINT
This checklist is a minimum standard. Manufacturer/supplier may require more.

You might also like