Product Data Sheet
Edition: 01.09
Version no. 03.08
Identification no: 01150139
Antisol®-WB
Curing Priming/Sealing and Surface Hardener Compound
for Freshly Laid Concrete
Product Antisol®-WB is a liquid curing compound for preventing the evaporation of mixing
Construction
Description water in concrete. It is ready for use and simple to apply. It is an un-degradable
compound, i.e. it is primer/sealer for another application.
Uses Antisol®-WB is suitable for trafficable surfaces. Antisol®-WB is sprayed onto newly
laid concrete surfaces to form a thin barrier against premature water loss. Without
disturbance to the normal setting action, the concrete is then allowed to cure and
achieve maximum properties.
®
Antisol -WB is particularly useful in large areas of exposed concrete, such as:
Highways
Runways and taxiways
Aprons and hard standings
Roof decks
Pre-stressed beams and piers
Irrigation canals/channels
Characteristics / Reduces incidence of plastic cracking
Advantages Ensure achievement of desired strengths
Minimise shrinkage
Reduces dusting
Increases frost resistance
Alleviates other costly methods such as Hessian - watering
Seals, prime & hardness of cement based composition
Approval / Standards Antisol®-WB complies with ASTM C 309-81 type 1 class A
Product Data
Form Liquid
Appearance / Colour White / milky
Packaging 5kg, 20kg. and 200kg drums
Storage Store in a dry area between 5ºC and 35ºC. Protect from direct sunlight
Storage Conditions/ 12 months minimum from production date if stored properly in original unopened
Shelf -Life packaging
1 Antisol®-WB 1/2
Technical Data
Chemical Base Acrylic Based Polymer
Density Approximately 1.02 kg/lit
System Information
Application Details
Consumption / Dosage The rate of coverage depends on wind, humidity and temperature. As a general
guide: 0.2 – 0.5 kg/m².
Application Conditions
Construction
Surface Condition The surface water of the newly laid concrete must have evaporated (between ½ to 2
hours depending on temperature etc…).
Application Instructions
Application Method / Stir the Antisol®-WB well before use.
Tools
®
The Antisol -WB has been designed for spray application to the newly laid concrete.
A thin film of Antisol® -WB is applied to the whole surface using hand or motor
operated spray gun. For large areas and concrete “trains”, application can be carried
out by power driven automatic equipment.
Cleaning of Tools Clean all equipment and tools with water
Notes on Application /
Antisol®-WB is un-degradable compound, so there is no need to remove it. It can be
Limitations
considered as a primer for future application.
Value Base All technical data stated in this Product Data Sheet are based on laboratory tests.
Actual measured data may vary due to circumstances beyond our control.
Health and Safety For information and advice on the safe handling, storage and disposal of chemical
Information products, users shall refer to the most recent Material Safety Data Sheet containing
physical, ecological, toxicological and other safety-related data.
Legal Notes The information, and, in particular, the recommendations relating to the application and end-use of Sika
products, are given in good faith based on Sika's current knowledge and experience of the products when
properly stored, handled and applied under normal conditions in accordance with Sika’s recommendations.
In practice, the differences in materials, substrates and actual site conditions are such that no warranty in
respect of merchantability or of fitness for a particular purpose, nor any liability arising out of any legal
relationship whatsoever, can be inferred either from this information, or from any written recommendations,
or from any other advice offered. The user of the product must test the product’s suitability for the intended
application and purpose. Sika reserves the right to change the properties of its products. The proprietary
rights of third parties must be observed. All orders are accepted subject to our current terms of sale and
delivery. Users must always refer to the most recent issue of the local Product Data Sheet for the product
concerned, copies of which will be supplied on request.
Sika Gulf BSC
Bldg. 925, Road 115, Tel: +973 17 738 188
Sitra Area 601. Fax: +973 17 732 476
P.O. Box 15776 e-mail:
[email protected] Adliya, Kingdom of Bahrain Web: http://www.sika.com.bh
2 Antisol®-WB 2/2
