Scribd
Upload
26 views

Arduino Uno Rev 3: Power Supply

The Arduino Uno Rev 3 is a microcontroller board with an ATmega328 chip. It has 14 digital input/output pins (6 can be used for PWM output), 6 analog inputs, operates at 16MHz and works with a 5V power supply (recommended input voltage is 7-12V). It has 32KB of flash memory, 2KB of SRAM and 1KB of EEPROM.

Uploaded by

Xim López Gelabert
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
26 views

Arduino Uno Rev 3: Power Supply

The Arduino Uno Rev 3 is a microcontroller board with an ATmega328 chip. It has 14 digital input/output pins (6 can be used for PWM output), 6 analog inputs, operates at 16MHz and works with a 5V power supply (recommended input voltage is 7-12V). It has 32KB of flash memory, 2KB of SRAM and 1KB of EEPROM.

Uploaded by

Xim López Gelabert
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

ARDUINO UNO Rev 3

Summary
Microcontroller ATmega328
Operating Voltage 5V
Input Voltage (recommended) 7-12V (9 V is recommended)
Input Voltage (limits) 6-20V
Digital I/O Pins 14 (of which 6 provide PWM output)
Analog Input Pins 6 (reading from 0 (0V) to 1023 (5V))
DC Current per I/O Pin 40 mA
DC Current for 3.3V Pin 50 mA
Flash Memory 32 KB (ATmega328)
SRAM 2 KB (ATmega328)
EEPROM 1 KB (ATmega328)
Clock Speed 16 MHz
Power supply
USB, power jack center-positive ,Vin, GND.
The internal circuitry is designed to switch from USB to external if the external supply exceeds 6.6V.
Maximum ratings
The IO pins have an absolute maximum rating of 40 mA per pin.
The following groups of pins should not have more than 100 mA drawn from them (each group):
 Digital pins 0 to 4
 Digital pins 5 to 13
 Analog pins A0 to A5
The entire processor chip has a maximum rating of 200 mA current consumption.
Async serial
The Rx pin is "inwards", that is from host computer to Arduino, and the Tx pin is "outwards", that is from the Arduino
to another device.
USB Overcurrent Protector
If more than 500 mA is applied to the USB port, the fuse will automatically break the connection.

You might also like