0% found this document useful (0 votes)
130 views

Model Data - For Compressed Air Atlas Copco Compressors, Inc GA 18 Pack 1

This document provides specifications for a rotary screw compressor model GA 18 Pack from Atlas Copco Compressors. The compressor has a rated capacity of 95 actual cubic feet per minute at a full load operating pressure of 150 pounds per square inch. It is powered by a 25 horsepower drive motor and has a total package input power of 24.4 kilowatts at rated capacity and full load operating pressure. The maximum full flow operating pressure is 157 pounds per square inch.
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
130 views

Model Data - For Compressed Air Atlas Copco Compressors, Inc GA 18 Pack 1

This document provides specifications for a rotary screw compressor model GA 18 Pack from Atlas Copco Compressors. The compressor has a rated capacity of 95 actual cubic feet per minute at a full load operating pressure of 150 pounds per square inch. It is powered by a 25 horsepower drive motor and has a total package input power of 24.4 kilowatts at rated capacity and full load operating pressure. The maximum full flow operating pressure is 157 pounds per square inch.
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Revised 5/02

COMPRESSOR DATA SHEET


Rotary Screw Compressor

MODEL DATA - FOR COMPRESSED AIR

1 Manufacturer: Atlas Copco Compressors, Inc

Model Number: GA 18 Pack

Air-cooled Water-cooled # of Stages: 1


2
Oil-injected Oil-free VALUE UNIT

3 Rated Capacity at Full Load Operating Pressure a, e 95 acfma, e

4 Full Load Operating Pressure b 150 psigb

5 Maximum Full Flow Operating Pressure c 157 psigc

6 Drive Motor Nameplate Rating 25 hp

7 Drive Motor Nameplate Nominal Efficiency 91.0 percent

8 Fan Motor Nameplate Rating (if applicable) 1 hp

9 Fan Motor Nameplate Nominal Efficiency 71 percent

Total Package Input Power at Rated Capacity and Full 24.4


10 kWd
Load Operating Pressured
Specific Package Input Power at Rated Capacity and Full
11 25.7 kW/100 cfm e
Load Operating Pressure e
NOTES:
a. Measured at the discharge terminal point of the compressor package in accordance with the CAGI/PNEUROP PN2CPTC2 Test
Code (Annex C to ISO 1217). ACFM is actual cubic feet per minute at inlet conditions.
b. The operating pressure at which the Capacity (Item 3) and Electrical Consumption (Item 10) were measured for this data sheet.
c. Maximum pressure attainable at full flow, usually the unload pressure setting for load/no load control or the maximum pressure
attainable before capacity control begins. May require additional power.
d. Total package input power at other than reported operating points will vary with control strategy.
e. Tolerance is specified in the CAGI/PNEUROP PN2CPTC2 Test Code (Annex C to ISO 1217) as follows:

Volume Flow Rate Volume Flow Rate Specific Energy Consumption


at specified conditions
m3 / min ft3 / min % %
Below 0.5 Below 15 +/- 7 +/- 8
Member
0.5 to 1.5 15 to 50 +/- 6 +/- 7
1.5 to 15 50 to 500 +/- 5 +/- 6
Above 15 Above 500 +/- 4 +/- 5


This form was developed by the Compressed Air and Gas Institute for the use of its members.
CAGI has not independently verified the reported data.

Form Number ROT 030

You might also like