2-1-14.

LENS SECTION
Screw
#53: M2.0 X 5.0 (Tapping) #155: M1.7 X 6.0 (Tapping)
(Black) (Black)
3-080-206-21 3-080-204-31

2.0 1.7

5.0 6.0

Note

Note1: Refer to page 2-2 “Note for disconnecting the harness Note1: ハーネス（同軸ケーブル）の交換時は2-2ページの Note
658 (coaxial cable)” when changing the harness (coaxial for disconnecting the harness (coaxial cable) を参照し
653 cable). てください。
658
#53
655 Note2: Be sure to read “Precuations for Replacement of Note2: イメージャの交換時は6-1ページの イメージャ交換時
#53
661 657 (including IC3001/IC5001 (CMOS imager)
Imager”on page 6-1 when changing the imager. の注意 を必ずお読みください。
and CM-097/104 complete boards) (Note 2)

660 654
#155 Note 3: Prism Device cautions
(Note 3)
Tighten screws in the following order.
#53 653 1

652 3

2
659
Be sure not to insert the harnesses forcefully.
(Standard: Insertion; 15N, Pull out; 10N)

Note 3: プリズムデバイス取り外し組立時の注意

下記の順番でねじを締め付けてください。

1
656
(Note 1) 651 3

ハーネスを強く差し込まないでください。
(差し込み時：15N, 引き抜き時：10N)

Ref. No. Part No. Description Ref. No. Part No. Description
651 1-788-775-31 LENS, VIDEO CF0022 656 1-966-281-11 HARNESS (COAXIAL CABLE) (Note 1)
* 652 4-119-361-01 HEAT SINK, LENS * 657 4-119-357-01 COVER (A), LIGHT INTERCEPTION
653 4-119-362-01 SHEET (2828), LENS RADIATION 658 4-119-356-01 SHEET (1122), LENS RADIATION
* 654 4-119-360-01 SHEET, CM RADIATION * 659 4-119-358-01 COVER (B), LIGHT INTERCEPTION
655 A-1566-526-A DEVICE (SERVICE), PRISM * 660 4-119-359-01 PLATE, GY GROUND
(including IC3001/IC5001 (CMOS imager) and
CM-097/104 complete boards) (Note 2) 661 A-1759-066-A GY-022 BOARD, COMPLETE (SERVICE)

#53 3-080-206-21 SCREW, TAPPING, P2

HXR-NX5C/NX5E/NX5J/NX5M/NX5N/NX5P/NX5U
2-16