THIS IS CONFIDENTIAL INFORMATION.
THIS DRAWING AND DESIGN IS THE PROPERTY OF LIQUIP INTERNATIONAL PTY LIMITED.
IT MUST NOT BE COPIED OR REPRODUCED IN ANY WAY WHATSOEVER AND/OR PASSED ON TO
ANY THIRD PARTY WITHOUT WRITTEN AUTHORITY.
LIQUIP INTERNATIONAL PTY LIMITED - ENGINEERING DEPARTMENT - 13 HUME RD SMITHFIELD SYDNEY NSW AUSTRALIA 2164
PH: +61 2 9725 9000 FAX: +61 2 9609 4739 EMAIL: [email protected]
LIQUIP MONITOR FOR OVERFILL AND GROUNDING
DATA SHEET PART N°: PD501 SERIES
TITLE: Multi-purpose monitor. Use for 5-wire probe overfill protection: also use for ground
assurance: also incorporates a single channel for 2-wire probes for railcar filling: or
combination of these.
PURPOSE: A single monitor per gantry now provides overfill protection combined with ground assurance
to offer lowest capital cost with simple and cheap installation wiring. Compatible with all
common probes.
OPERATION: Output from the monitor is a single triple-ganged relay signal to provide a go or no-go control
for operation of the gantry or tank farm. Indication is by red or green lamp and a lockable
by-pass switch is standard. Truck plugs may be standard or optic style. Ground assurance
connector may be via truck plug, or ground ball socket, or ‘crocodile’ clamp.
SPECIFICATION: Explosionproof housing for Zone 1, monitoring signals intrinsically safe Zone 0.
Power supply 240VAC or 110VAC. Output (control) relay triple-ganged for reliability,
normally open, volt-free rated at 5 amp 240V (if power output is required, contact Liquip).
Lockable by-pass switch to enable loading in emergency. Cable entries 3/4" NPS, adaptors
to 25mm conduit thread available. Shutdown response time 0.5 seconds for all fault
conditions. All model variants are factory set and tested, however site changes are easily
carried out as it is controlled by wiring changes on output terminal strip. Therefore only one
monitor design is required throughout the terminal and tank farm.
SAFETY
CERTIFICATION: ATEX Certificate: TRL03ATEX11007X
Marking: EEx d [ia] IIB T6
0518 II 2 [1] G
Parameters: Uo = 17V, Io = 179mA, Co = 1.8µF, Lo/Ro = 200µH/Ω
VARIANTS: Simple linkages provide the following variations of the same monitor:
5-wire probe overfill monitor
2-wire probe overfill monitor single channel
Ground assurance monitor with crocodile clamp
Overfill monitor with ground assurance wired through truck plug
Overfill monitor with separate cable (clamp or ball type) for ground assurance
All the above in 110VAC or 240VAC power supply
MOUNTING: See attached diagram.
SERVICE: Self-calibrating, no adjustments required. One solid-state board with plug-connector for
quick site change-over.
MATERIAL OF
CONSTRUCTION: Aluminium housing. Explosion proof polycarbonate lights and switch.
WEIGHT: 8 kg.
ASSOCIATED LDP102, LDP105, AGP202 & AGP205 optical probes.
EQUIPMENT: See data sheet for accessories for monitors. Includes junction box for intrinsically safe
cabling. Optic and standard gantry plugs and self-store cable. Crocodile clamp and self-
store cable for grounding. Ball socket and self-store cable for grounding.
Overall dimensions shown on the drawing overleaf.
PDxxx_SALE_PD501_SERIES_MONITOR_DATASHEET_PD00197.doc Issue: G 14/12/09 Page 1
THIS IS CONFIDENTIAL INFORMATION.
THIS DRAWING AND DESIGN IS THE PROPERTY OF LIQUIP INTERNATIONAL PTY LIMITED.
IT MUST NOT BE COPIED OR REPRODUCED IN ANY WAY WHATSOEVER AND/OR PASSED ON TO
ANY THIRD PARTY WITHOUT WRITTEN AUTHORITY.
LIQUIP INTERNATIONAL PTY LIMITED - ENGINEERING DEPARTMENT - 13 HUME RD SMITHFIELD SYDNEY NSW AUSTRALIA 2164
PH: +61 2 9725 9000 FAX: +61 2 9609 4739 EMAIL:
[email protected]PDxxx_SALE_PD501_SERIES_MONITOR_DATASHEET_PD00197.doc Issue: G 14/12/09 Page 2
THIS IS CONFIDENTIAL INFORMATION.
THIS DRAWING AND DESIGN IS THE PROPERTY OF LIQUIP INTERNATIONAL PTY LIMITED.
IT MUST NOT BE COPIED OR REPRODUCED IN ANY WAY WHATSOEVER AND/OR PASSED ON TO
ANY THIRD PARTY WITHOUT WRITTEN AUTHORITY.
LIQUIP INTERNATIONAL PTY LIMITED - ENGINEERING DEPARTMENT - 13 HUME RD SMITHFIELD SYDNEY NSW AUSTRALIA 2164
PH: +61 2 9725 9000 FAX: +61 2 9609 4739 EMAIL:
[email protected]PDxxx_SALE_PD501_SERIES_MONITOR_DATASHEET_PD00197.doc Issue: G 14/12/09 Page 3
