Technical Data

On-Line UPS-system proTECTO 700-3000

The proTECTO is a On-Line double

conversion UPS-system according to IEC / EN
62040-3 (VFI-SS-111) with sinus wave output
voltage in each operation mode, LCD-
indication, RS232 interface, USB-connection,
slot for communication cards and Shutdown-
software for Windows 7 / 2008 / Vista / 2003 /
XP, Novell and Linux system software.
Operation modes (selectable on display): On-
Line, Line-Interactive, Smart Active or
Standby.
The back-up time of the system can be
increased by connecting additional external
battery modules.

model proTECTO 700 1000 1000 1500 2200 2200 3000 3000
ER ER ER

rating
rating in VA 700 1000 1000 1500 2200 2200 3000 3000
rating in W 560 800 800 1200 1760 1760 2400 2400

back-up time back-up time in minutes

100% load 6 7 0 5 6 0 5 0
50% load 15 18 0 15 16 0 15 0

input
nominal voltage 220 / 230 / 240 V AC
input voltage range at 50% load 140 – 276 V
input voltage range at 100% load 184 – 276 V
input frequency range 50 Hz ± 5% / 60 Hz ± 5%
nominal frequency standard 50 Hz, adjustable by software, 50 Hz, 60 Hz or
auto select
tolerance of frequency ±5%
nominal current in A 3,3 4,5 6 6,5 9,5 13,5 12,5 16
(nominal load and charged capacitors, input
voltage 230 Volt)
maximum input current in A 3,7 5,2 10 7,8 11,2 16 15,5 20
(nominal load, minimum input voltage and
capacitor charging)
inrush current < nominal current
power factor (cos ϕ) > 0,98
harmonical distortion (THDI) 7%
„Hold-Up Zeit“ < 40 ms
(back-up time which can be ralized without
switching on capacitor – no interruption of
the output voltage occures)

proTECTO 700-3000 Seite 1 von 9 Stand: 06-2010

Technische Änderungen vorbehalten
 Technical Data
On-Line UPS-system proTECTO 700-3000

model proTECTO 700 1000 1000 1500 2200 2200 3000 3000
ER ER ER

output
output voltage 230 V (adjustable to 220 or 240 V)
tolerance of output voltage - static ± 1,5 %
tolerance of output voltage – dynamic (load 5%
impact 0 to 100%)
voltage reset after dynamic variation < 20 ms
waveform of output voltage sinus
output frequency in normal operation 50 or 60 Hz ± 5 %
rate of frequency adjustment 1 Hz / s
output frequency in capacitor operation 50 or 60 Hz ± 0,2 %
voltage distortion / linear load <2%
voltage distortion / non-linear load <4%
power factor output 0,8
crest factor according to EN 50091-1 til 3:1
(peak current to RMS-current)
efficiency 98 %
(ECO Mode and Smart Active)

overload
overload in normal operation 100 - < 110% about 2 minutes
(afterwards switch over bypass) 110 - < 150% about 4 seconds
> 150% about 1 second
overload in battery operation 100 - < 110 % about 1 minute
(afterwards switch off) 110 - < 150 % about 4 seconds
> 150 % about 0,5 seconds
short-circuit current 3 x I Nenn about 0,5 seconds

bypass
voltage tolerance for switch over 180 – 264 Volt
tolerance of frequency from ± 0,5 Hz til ± 5Hz adjutable
time to switch over 2 ms

battery
nominal voltage 24 V 36 V 36 V 36 V 72 V 72 V 72 V 72 V
number of modules 2 3 * 3 6 * 6 *
nominal capacity per module 7 Ah 7 Ah * 9 Ah 7 Ah * 9 Ah *
type closed and maintenance-free
life duration 3 - 6 years (depending on environmental conditions)
recharge time appr..4 hours
charge current 0,8 A 0,8 A 7 A 0,8 A 0,8 A 8 A 0,8 A 8 A
battery test automatical each 40 hours

* external batteries

proTECTO 700-3000 Seite 2 von 9 Stand: 06-2010

Technische Änderungen vorbehalten
 Technical Data
On-Line UPS-system proTECTO 700-3000

model proTECTO 700 1000 1000 1500 2200 2200 3000 3000
ER ER ER

displays
normal operation icon at LCD-display illuminate
battery operation icon at LCD-display illuminate, UPS beeps all 4 seconds
battery discharged icon at LCD-display blinking, UPS beeps 1 time per
second
bypass active icon at LCD-display illuminate
stand by icon at LCD-display illuminate
maintenance necessary icon at display illuminate
load LCD-display
capacitor charge LCD-display

control and command buttons

button ON
button SELECT
button STANDBY
switch Main switch

interfaces
Sub-D 9 Pin socket RS 232 interface
USB-Port USB-interface
slot slot for communication plug-in card

connections
input IEC 10 A IEC 16 A
output 4 x IEC 10 A 8 x IEC 10 A 8 x IEC 10 A
+ 1 IEC 16 A
Input fuse (thermal fuse) in A 7 (10 ER-version) 10 12 (16 ER 16 (20 ER
version) version)
DC-connection for battery module no standard no standard

protection
protections over current – short circuit – over voltage - low voltage
heat – deep discharge protection of the batteries
Impuls withstand voltage IEC 801-5 6 KV 1.2 / 50 µsec; 3 KA 8/20 µsec; 300 Joule

norms and regulations

safety EN 62040-1-1; regulation 2006 / 95 / EL
EMV / RFI EN 62040-2 category 2 and regulation 2004 / 108 / EL
operational requirements EN 62040 – 3 VFI-SS-111

environmental conditions
environmental temperature 0 up to 40°C
relative air humidity < 95% non-condensing
noise level in 1 m distance < 40 dB(A)

proTECTO 700-3000 Seite 3 von 9 Stand: 06-2010

Technische Änderungen vorbehalten
 Technical Data
On-Line UPS-system proTECTO 700-3000

model proTECTO 700 1000 1000 1500 2200 2200 3000 3000
ER ER ER

cabinet
material sheet steel / front plastics
colour black
protection class IP 20

dimensions
dimensions (H x W x D) in mm 235 x 158 x 422 333 x 190 x 446

weight
weight in kg 11 13,5 7* 15 26 10,6* 28 14*

delivery
manual in german (on CD-ROM) yes
schuko/IEC mains cable 1
IEC/IEC connection cable 2
plug for battery-increase - 1 - 1 - 1
RS232 connection cable 1
USB-cable 1
shutdown-software for Windows 7 / 2008 / yes
Vista / 2003 / XP, Novell and Linux system
on CD-ROM.

options
external service by-pass
manual by-pass switches the load from the
inverter to the mains power supply without
interrupting the output power supply in case
of maintenance
dimensions (H x W x D) in mm 180x300x115
weight in kg 3

SNMP card
NetMan 102 Plus SNMP interface-card X

software
network version of PowerShield³ shutdown-
software for Windows 7 / 2008 / Vista /
2003 / XP, Novell, UNIX and Linux system. X
*external batteries

proTECTO 700-3000 Seite 4 von 9 Stand: 06-2010

Technische Änderungen vorbehalten
 Technical Data
On-Line UPS-system proTECTO 700-3000

View of the UPS

FRONT VIEW

REAR SIDE

model 700VA / 1500VA model 1000 VA

display fan

multifunction-buttons connection for battery increase

main switch outlet IEC 10A

RS232-Port input plug IEC 10A

USB-Port thermal input fuse

slot for plug-in card

proTECTO 700-3000 Seite 5 von 9 Stand: 06-2010

Technische Änderungen vorbehalten
 Technical Data
On-Line UPS-system proTECTO 700-3000

rear side

model 2200VA

model 3000VA

communication port RS232 and contacts outlet IEC 16A

USB-Port outlet IEC 10A

slot for plug-in card input plug IEC 16A

fan input plug IEC 10A

connection fo battery increase thermal input/output fuse

proTECTO 700-3000 Seite 6 von 9 Stand: 06-2010

Technische Änderungen vorbehalten
 Technical Data
On-Line UPS-system proTECTO 700-3000

View of the display

button „SEL“ charge level

button „ON“ load level

button „STAND-BY“ configurations

normal operation maintenance required

mains ok timer

battery operation indicated value

load on bypass stand-by / alarm

proTECTO 700-3000 Seite 7 von 9 Stand: 06-2010

Technische Änderungen vorbehalten
 Technical Data
On-Line UPS-system proTECTO 700-3000

communication-ports
On the rear side of the ups you can find the following communication ports:
• RS232-plug

• USB-plug

• Plug-in slot for optional communication cards

RS232-interface

RS232-interface

PIN # SIGNAL COMMENTS

Adjustable output *:
1
[standard: UPS-system error]
2 TXD
3 RXD
Adjustable input **: (*) optical contact max. +30 Vdc / 35 mA.
4
[standard: not active] adjustable by use a special software
5 GND
(**) optical isolated input +5 bis 15 Vdc. (PIN 4/6 and 7/6)
6 +12 Vdc (Imax = 80mA)
adjustable by use a special software
Adjustable input **:
7
[standard: not active]
Adjustable output *:
8
[standard: capacitors depleted]
Adjustable output *:
9
[standard: mains failure]

proTECTO 700-3000 Seite 8 von 9 Stand: 06-2010

Technische Änderungen vorbehalten
 Technical Data
On-Line UPS-system proTECTO 700-3000

communication-slot

The UPS system is equipped with an expansion slot for optional

communication cards (see accompanying figure) provided that the
device using the dialog to enable the most important
communications standards.
Some examples:
• second USB- and RS232-port

• multiplexer doubles the serial port

• ethernet-network-plug-in card with protocol TCP/IP, HTTP

and SNMP

• protocol-converter-plug-in card JBUS / MODBUS

• protocol-converter-plug-in card PROFIBUS

• slot with isolated relay card

proTECTO 700-3000 Seite 9 von 9 Stand: 06-2010

Technische Änderungen vorbehalten