PURBANCHAL UNIVERSITY
Time-bound Home Exam 2020
B.E. (Electrical)/Third Semester/Final
Time: 03:00 hrs. (+2 Hrs. for Submission) Full Marks: 80 /Pass Marks: 32
BEG223EL: Electric Circuit Theory
Instructions:
Dear Students!
• This model of examination is for you as the end of your current semester. This examination allows you
to write answer from your own place of residence. Follow the following instructions without fail.
• Do not write your name in the answer-sheet(s).
• All the answer-sheets should be sent to college through your approved email in which you have
received your question paper.
• Do not write questions in the answer-sheet but mention clearly the question number.
• All the scan/photos of answer-sheets should be clearly visible. Any blur scan/photo will not be
considered for evaluation. Responsibility lies with the students to make sure that scan/photos of the
answer-sheet are of readable quality.
• Leave 1 inch margin on each side of the answer-sheet.
• Clearly mention your Roll no, subject, program, semester, page number at the right-top of each page as
instructed by the Office of the Examination Management.
• Make sure that you send your answer-sheets within the given time. Any email received after the given
time will not be acceptable.
• You are strictly advised to write with your own handwriting and that you are not using any unfair
means to answer the questions.
• Do not consult during the examination period to any other person in answering the questions.
• Do not post any pictures of taking examination or your answer-sheets in any social-media. Found that
may be taken action from University.
All questions carry equal marks. The marks allotted for each sub-question is specified along its side. Assume
suitable data f necessary.
Answer FIVE questions. 516=80
1(a) Define the following terms. 8
(i) Ideal and Practical Voltage and Current Source
(ii) Periodic and Aperiodic Signal
(iii) Active and Passive Network System
(iv) Lumped and Distributed network
(b) Formulate matrix model for given circuit using mesh analysis and hence solve for mesh current
using Cramer's rule. 8
2(a) Switch in the given circuit is suddenly open at t=0 after steady state has been reached in closed position
of switch, determine the expression for voltage across capacitor for t >0. 8
Contd. ...
(2)
(b) Consider the RLC series circuit shown in figure. Determine: 8
3(a) In the circuit shown in figure below the switch is closed at t = 0, find the expression for i1(t) and i2(t)
using Laplace transform method, if the circuit is energize before the switch is closed. 8
(b) Use pole-zero plot to determine residues of the transfer function and hence obtain the time response:
S
G(s) . 4
s 4 )( s 6
(c) State and prove final value theorem. 4
20 ( s 1)
4(a) Draw the asymptotic Bode plot for the given transfer function. G(s) . 8
s s 2 2s 10 )( s 5
(b) The given network is driven by a current source and is terminated by resistor R2 at port 2. For this
terminated 2-port network calculate: 8
(i) Transfer function G21(s), Z21(s) and Y21(s)
(ii) Driving point impedance Z11(s)
5(a) Find the Fourier series representation of waveform given in figure using trigonometric Fourier series.
8
(b) Find the y-parameter for the given resistive network containing a controlled voltage. 8
Contd. ...
(3)
6(a) A step current of 4e-t is applied to parallel RLC circuit having R=2Ω, L=1H and C=1F. Obtain the
expression for voltage using Laplace transformation technique. Assume that capacitor and inductor
are initially uncharged. 8
(b) Explain reciprocity property and symmetry property of a two-part network. Derive the condition for
reciprocity and symmetry in terms of ABCD parameters. 8
