Scribd
Upload
13 views

01-05-062 Inverse Functions and Logarithms

This document summarizes the process of finding the inverse function of Q(t) = Q0(1 - e-t/a), which models the recharging of a camera flash capacitor over time. The inverse function gives time (t) as a function of charge (Q). It is found to be t = -a ln(1 - Q/Q0). For a capacitor with a = 2, the time to recharge to 90% capacity is calculated to be approximately 4.6 seconds by substituting into the inverse function.

Uploaded by

Sourin Sarkar
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
13 views

01-05-062 Inverse Functions and Logarithms

This document summarizes the process of finding the inverse function of Q(t) = Q0(1 - e-t/a), which models the recharging of a camera flash capacitor over time. The inverse function gives time (t) as a function of charge (Q). It is found to be t = -a ln(1 - Q/Q0). For a capacitor with a = 2, the time to recharge to 90% capacity is calculated to be approximately 4.6 seconds by substituting into the inverse function.

Uploaded by

Sourin Sarkar
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Calculus I, Section 1.

5, #62
Inverse Functions and Logarithms

When a camera flash goes off, the batteries immediately begin to recharge the flash’s capacitor, which stores
electric charge given by
 
Q(t) = Q0 1 − e−t/a

(The maximum charge capacity is Q0 and t is measured in seconds.)1


(a) Find the inverse of this function and explain its meaning.

Q(t) = Q0 1 − e−t/a gives charge as a function of time. Thus the inverse will give time as a function
of charge. That is, when we input a specific amount of charge, the output will tell us the time when
that charge was reached.
 
Q = Q0 1 − e−t/a

and we solve for t


Q
= 1 − e−t/a
Q0
Q
− 1 = −e−t/a
Q0
Q
− + 1 = e−t/a
Q0

taking the natural log of both sides


 
Q  
ln 1 − = ln e−t/a
Q0
 
Q
ln 1 − = −t/a
Q0
 
Q
−a · ln 1 − =t
Q0

So, in function form,


 
Q
t = T (Q) = −a ln 1 −
Q0

(b) How long does it take to recharge the capacitor to 90% of capacity if a = 2?
We substitute a = 2 and Q = 0.90Q0 into the inverse function.
 
Q
T (Q) = −2 ln 1 −
Q0
 
0.90Q0
T (0.90Q0 ) = −2 ln 1 −
Q0
T (0.90Q0 ) = −2 ln (1 − 0.90)
T (0.90Q0 ) = −2 ln (0.10)
T (0.90Q0 ) ≈ 4.6052

Thus the charge will be at 90% after about 4.6 sec.


1 Stewart, Calculus, Early Transcendentals, p. 68, #62.

You might also like