Intrusion Systems | Blue Line ISM-BLA1-CM Monochrome Camera Modules
Blue Line ISM-BLA1-CM Monochrome
Camera Modules
▶ Pinhole charge-coupled device (CCD) camera with 3 lx
light sensitivity
▶ 380 TV lines of horizontal resolution
▶ The camera can be left on or controlled by the detector
alarm.
▶ Selectable (Form A or Form B) alarm relay outputs
▶ Includes video cable with BNC connector
▶ Available in EIA or CCIR format
The ISM-BLA1-CM monochrome camera modules attach to Installation/Configuration Notes
the Blue Line detectors. These camera modules, available
in either EIA or CCIR format, are small, easy-to-mount, and Camera Viewable Area
attractive. Set the camera to run continuously, or to run for The camera's field of view is 66° horizontal and 53° vertical.
either 15 sec or 90 sec when activated by the detector The resulting viewable area depends on the installation
alarm. height. An example for a 2.3 m (7.5 ft) installation height is
The ISM-BLA1-CM-C provides a video output of CCIR shown below:
Standard 625 lines interlaced. Includes video output cable Viewable Area Legend
with BNC connector. It has shutter speeds from 1/50 sec to
1/100000 sec.
The ISM-BLA1-CM-E camera module provides a 1 V p-p
standard composite video signal, EIA Standard 525 lines
interlaced, into 75 Ω. It has shutter speeds from 1/60 sec
to 1/100000 sec.
Certifications and Approvals
ISM-BLA1-CM-E
Country Certification/Listing Number
US UL ANSR: Intrusion Detection Units (UL639)
ISM-BLA1-CM-C
Country Certification/Listing Number
Europe X
Complies with EN50131-1 grade 2
Czech Republic NBU
www.boschsecurity.com
2 | Blue Line ISM-BLA1-CM Monochrome Camera Modules
Parts Included
Quant. Component
1 Camera module
1 Mask
1 Hardware pack
1 Literature pack
Top View
Side View
Note The passive-infrared (PIR) coverage patterns
and look-down zone depend on the specific
detector used. Refer to the detector's
datasheet.
Note A pair of masks are provided to reduce the
detector's PIR coverage area since that area is
larger than the camera's field of view.
Power Considerations
Power Limits
Input power must be provided by an Approved Limited
Power Source. All outputs must be connected to SELV
(safety extra-low voltage) circuits only.
Standby Power
This detector has no internal standby battery. For UL Listed
product installations, 4 hr (20 mAh with camera off, 460 mAh
with camera on) of standby power must be supplied by the
control unit or by a UL Listed burglary power supply.
Video Connection
A video cable with a BNC connector at one end is supplied.
Connect this cable to up to 152 m (500 ft) of 75 Ω RG59/U
or similar coaxial cable.
Blue Line ISM-BLA1-CM Monochrome Camera Modules | 3
Technical Specifications Ordering Information
Blue Line ISM-BLA1-CM Monochrome Camera ISM-BLA1-CM-C
Environmental Considerations Module (CCIR Format)
Complies with EN50131 Environmental Class II, Security Grade 2 Blue Line ISM-BLA1-CM Monochrome Camera ISM-BLA1-CM-E
Module (EIA format)
Relative Humidity: 0 to 85%, non-condensing
Temperature (operating): -10°C to +49°C (+14°F to +120°F)
For UL Listed product installations, 0°C to
+49°C (+32°F to +120°F)
Input
Alarm: 5 V normally from sensor digital alarm output, ground for
4 sec during alarm.
Mechanical Properties
Color: White
Dimensions: 5.6 cm x 6.1 cm x 4.8 cm
(2.2 in. x 2.4 in. x 1.9 in.)
Material: High-impact ABS plastic
Radio Frequency In- No alarm or setup on critical frequencies in the range
terference (RFI) Im- from 26 MHz to 2 GHz at field strengths less than 30 V/
munity: m.
Outputs
Relay Timer: Selectable latch time of 15 sec or 90 sec
Timed Relay: Solid state, selectable supervised Form A normally-
closed (NC) or unsupervised Form B normally-open (NO)
contacts rated for 125 mA, 28 VDC, 3 W.
Tamper: Normally-closed (NC) contacts (with cover on) rated at
28 VDC, 125 mA maximum. Connect to detector tamper
circuit.
Power Requirements
Current (Alarm): 115 mA when camera is on.
Current (Standby): 5 mA maximum at 12 VDC
Voltage (Operating): 12 VDC nominal
Video
CCD: 8.5 mm (1/3-inch) color with an electronic
shutter
Field of view: 66° horizontal, 53° vertical
Lens: Pinhole lens with a 75° field of view
Resolution (horizontal): 380 lines minimum at center of picture
Scanning System: 2:1 interlaced
Sensitivity: <3 lx
Signal: 75 Ω (CCIR or EIA)
Signal to Noise Ratio: 48 dB minimum
Europe, Middle East, Africa: Americas: Asia-Pacific: Represented by
Bosch Security Systems B.V. Bosch Security Systems, Inc. Bosch Security Systems Pte Ltd
P.O. Box 80002 130 Perinton Parkway 38C Jalan Pemimpin
5600 JB Eindhoven, The Netherlands Fairport, New York, 14450, USA Singapore 577180
Phone: + 31 40 2577 284 Phone: +1 800 289 0096 Phone: +65 6319 3450
Fax: +31 40 2577 330 Fax: +1 585 223 9180 Fax: +65 6319 3499
[email protected] [email protected] [email protected]www.boschsecurity.com www.boschsecurity.us www.boschsecurity.com
© Bosch Security Systems 2006 | Data subject to change without notice
F1231760651 | Cur: en-US, V8, 25 Sep 2006
