Scribd
Upload
35 views

Technical Data Sheet: Thermax™ Pei (Made Using Ultem™ 1010)

Datasheet, ULTEM1010

Uploaded by

nhzaidi
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
35 views

Technical Data Sheet: Thermax™ Pei (Made Using Ultem™ 1010)

Datasheet, ULTEM1010

Uploaded by

nhzaidi
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

TDS Rev 4.

Technical Data Sheet: ThermaX™ PEI [Made using ULTEM™ 1010]

Physical Properties Standard Unit Metric


Density ISO 1183 g/cc 1.27

Mechanical Properties Standard Unit Metric


Tensile Strength ISO 527 MPa 56
Tensile Modulus ISO 527 MPa 2500
Tensile Elongation ISO 527 % 3
Flexural Strength ISO 178 MPa 110
Flexural Modulus ISO 178 MPa 2510

Thermal Properties Standard Unit Metric


Glass Transition Temperature
DSC °C 217
(Tg)
Deflection Temperature at 0.45
ISO 75 °C 208
MPa (66psi)

Fire Testing* Standard Unit Typical Value


Flamability Rating (*Base Resin) UL 94 - V-0 @1.5mm

Printed Specimen Conditions


Printer: Open Source FDM/FFF
Nozzle: 0.4mm
Layer Height: 0.25mm
Infill: 100%, +/- 45°
Extrusion Temp: 380-400°C
Bed Temp: 130-140°C
Specimen Orientation: XY Flat
Disclaimer: The technical data contained on this data sheet is
furnished without charge or obligation and accepted at the

www.3dxtech.com
recipient’s sole risk. This data should not be used to establish
specifications limits or used alone as the basis of design. The
data provided is not intended to substitute any testing that may
be required to determine fitness for any specific use.
ULTEM™ is a registered trademark of Sabic IP

You might also like