R1510S Series

Automatic Mode shift 300mA 36V Input VR with VD

The R1510S Series are CMOS-based auto mode switching voltage regulators featuring 300mA output current with voltage detector.
The R1510S has a 36V maximum input voltage VR and VD on a single chip. As the voltage regulator is an automatic mode shift type,
the operation can switch automatically to a fast response mode or a low power mode of the ECO function according to output current.
(Automatic switching to fast response mode under IOUT > 12mA conditions or to low power mode under IOUT < 3mA conditions.)
R1510S with a built-in voltage detector is available in four versions. The differences between these versions are in CE pin, points to
be detected, and delay function.
∗) These products are suitable for automotive applications too. Please refer to our "Car Electronics Products Catalog" or contact us.

FEATURES
• Supply Current (ISS2) ····················· Typ. 110μA (Fast mode, VIN=14.0V) < Voltage Detector >
• Supply Current (ISS1) ····················· Typ. 12.5μA (Low power mode, same as above) • Detector Threshold Range (-VDET)··· 2.3V to 12.0V ∗ (Internally fixed)
• Standby Current (Istandby) ················· Typ. 10μA (Same as above, CE="L", only A Version) (D Version : 2.3V to 10.6V)
• Dropout Voltage (VDIF) ···················· Typ. 1.0V (IOUT=300mA, VSET=5.0V) • Detector Threshold Accuracy ········· ± 1.7%
• Input Voltage Range (VIN) ··············· 3.5V to 36.0V • Temp. coeff. of Detector Threshold··· Typ. ± 100ppm/°C
• Output Voltage Range (VOUT)·········· 2.5V to 12.0V ∗ (Internally fixed) • Output Delay Time Setting Pin (C/D Versions)
• Output Voltage Accuracy ················± 1.6% • Output Delay Time (tdelay) =7.0 × CD (F) × 105 (s)
• Temp. coeff. of Output Voltage ······· Typ. ± 150ppm/°C • Operating Temperature Range
• Line Regulation······························· Typ. 0.01%/V (Absolute Maximum Rating)··········· -40°C to 110°C
• Fold-back Protection Circuit ··········· Current limit Typ. 50mA • Package ········································· HSOP-8E
• Thermal Shutdown Circuit ·············· Stops at 140°C • Ceramic capacitors can be used.··· 6.8μF or more
(The above shows specification at Topt=25°C. Design assurance value at -40°C ≤ Topt ≤ 110°C is also available. For details, please refer to the datasheet.)
∗) For information about combination of output voltage and detector threshold, please check our website.

BLOCK DIAGRAMS
R1510SxxxA R1510SxxxB R1510SxxxC R1510SxxxD
(With CE pin, VIN detect) (with SENSE pin) (With CD pin, VIN detect) (With CD pin, VOUT detect)

VDD 5 1 VOUT VDD 5 1 VOUT VDD 5 1 VOUT VDD 5 1 VOUT

Vref Vref Vref Vref

Thermal Thermal Thermal Thermal

Shutdown Current Limit Shutdown Current Limit Shutdown Current Limit Shutdown Current Limit
2 GND 2 GND 2 GND 2 GND
CE 3 SENSE 3
CD 3 CD 3
Internal Internal Internal Internal
Supply Voltage 4 DOUT Supply Voltage 4 DOUT Supply Voltage 4 DOUT Supply Voltage 4 DOUT

Vref Vref Vref Vref

SELECTION GUIDE
Halogen Free Package Q'ty per Reel Part No. .xxx : Specify a combination of output voltage and detector threshold using
serial numbers.
HSOP-8E 1,000 pcs R1510S.xxx.∗ -E2-FE .∗ : Select from (.A.) with CE pin and VIN detect, (.B.) with SENSE pin,
(.C.) with CD pin and VIN detect, or (.D.) with CD pin and VOUT detect.

PACKAGE TYPICAL CHARACTERISTIC

HSOP-8E R1510S (VR=12.0V) Output Voltage vs. Output Current
Top View Bottom View
8 7 6 5 5 6 7 8 14

12
Output Voltage VOUT (V)

∗
10

8 VIN=12.4V
1 2 3 4 4 3 2 1
VIN=12.6V
6 VIN=12.8V
1 VOUT 5 CE or SENSE or CD VIN=13.0V
4
2 NC 6 TP (Test pin) VIN=13.2V
3 TP (Test pin) 7 GND 2
4 DOUT 8 VDD 0
∗) The tab is substrate level (GND). 0 100 200 300 400 500 600 700
Output Current IOUT (mA)

APPLICATIONS
• Power source for home appliances (refrigerators, rice cookers, electric water warmers, etc.) and reset circuits
• Power source for in-car audio systems, in-car navigation systems, ETC systems, and reset circuits
• Power source for laptop personal computers, digital TVs, cordless phones, and private LAN systems for home, and reset circuits
• Power source for copiers, printers, facsimiles, scanners, and reset circuits

No.EK-185-121001 CMOS Voltage Regulator

 1. The products and the product specifications described in this document are subject to change or
discontinuation of production without notice for reasons such as improvement. Therefore, before
deciding to use the products, please refer to Ricoh sales representatives for the latest
information thereon.
2. The materials in this document may not be copied or otherwise reproduced in whole or in part
without prior written consent of Ricoh.
3. Please be sure to take any necessary formalities under relevant laws or regulations before
exporting or otherwise taking out of your country the products or the technical information
described herein.
4. The technical information described in this document shows typical characteristics of and
example application circuits for the products. The release of such information is not to be
construed as a warranty of or a grant of license under Ricoh's or any third party's intellectual
property rights or any other rights.
5. The products listed in this document are intended and designed for use as general electronic
components in standard applications (office equipment, telecommunication equipment,
measuring instruments, consumer electronic products, amusement equipment etc.). Those
customers intending to use a product in an application requiring extreme quality and reliability,
for example, in a highly specific application where the failure or misoperation of the product
could result in human injury or death (aircraft, spacevehicle, nuclear reactor control system,
traffic control system, automotive and transportation equipment, combustion equipment, safety
devices, life support system etc.) should first contact us.
6. We are making our continuous effort to improve the quality and reliability of our products, but
semiconductor products are likely to fail with certain probability. In order to prevent any injury to
persons or damages to property resulting from such failure, customers should be careful enough
to incorporate safety measures in their design, such as redundancy feature, firecontainment
feature and fail-safe feature. We do not assume any liability or responsibility for any loss or
damage arising from misuse or inappropriate use of the products.
7. Anti-radiation design is not implemented in the products described in this document.
8. Please contact Ricoh sales representatives should you have any questions or comments
concerning the products or the technical information.

For the conservation of the global environment, Ricoh is advancing the decrease of the negative environmental impact material.
After Apr. 1, 2006, we will ship out the lead free products only. Thus, all products that will be shipped from now on comply with RoHS Directive.
Basically after Apr. 1, 2012, we will ship out the Power Management ICs of the Halogen Free products only. (Ricoh Halogen Free products are
Halogen Free also Antimony Free.)

RICOH COMPANY, LTD.

Electronic Devices Company
http://www.ricoh.com/LSI/

RICOH COMPANY, LTD.

Electronic Devices Company
● Higashi-Shinagawa Office (International Sales)
3-32-3, Higashi-Shinagawa, Shinagawa-ku, Tokyo 140-8655, Japan
Phone: +81-3-5479-2857 Fax: +81-3-5479-0502

RICOH EUROPE (NETHERLANDS) B.V.

● Semiconductor Support Centre
“Nieuw Kronenburg”Prof. W.H. Keesomlaan 1, 1183 DJ, Amstelveen, The Netherlands
P.O.Box 114, 1180 AC Amstelveen
Phone: +31-20-5474-309 Fax: +31-20-5474-791

RICOH ELECTRONIC DEVICES KOREA Co., Ltd.

11 floor, Haesung 1 building, 942, Daechidong, Gangnamgu, Seoul, Korea
Phone: +82-2-2135-5700 Fax: +82-2-2135-5705

RICOH ELECTRONIC DEVICES SHANGHAI Co., Ltd.

Room403, No.2 Building, 690#Bi Bo Road, Pu Dong New district, Shanghai 201203,
People's Republic of China
Phone: +86-21-5027-3200 Fax: +86-21-5027-3299

RICOH COMPANY, LTD.

Electronic Devices Company
● Taipei office
Room109, 10F-1, No.51, Hengyang Rd., Taipei City, Taiwan (R.O.C.)
Phone: +886-2-2313-1621/1622 Fax: +886-2-2313-1623