Scribd
Upload
147 views2 pages

SCSJ-IISCSJ-III Water Purifier

This document summarizes the specifications of two water purification systems: the SCSJ-II and SCSJ-III. Both systems use pretreatment with physical filters and activated carbon followed by reverse osmosis and deionization to purify tap water. The SCSJ-III has a higher flow rate of 30 liters/hour compared to 15 liters/hour for the SCSJ-II. The pure water quality from both systems is high with TDS below 10 ppm and a resistivity over 15 MΩ.cm. The systems are intended for use in fine chemistry industries, laboratories, and producing aseptic drinking water.

Uploaded by

elias martinez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
147 views2 pages

SCSJ-IISCSJ-III Water Purifier

This document summarizes the specifications of two water purification systems: the SCSJ-II and SCSJ-III. Both systems use pretreatment with physical filters and activated carbon followed by reverse osmosis and deionization to purify tap water. The SCSJ-III has a higher flow rate of 30 liters/hour compared to 15 liters/hour for the SCSJ-II. The pure water quality from both systems is high with TDS below 10 ppm and a resistivity over 15 MΩ.cm. The systems are intended for use in fine chemistry industries, laboratories, and producing aseptic drinking water.

Uploaded by

elias martinez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

SCSJ-II/SCSJ-III Water Purifier

(RO/DI water)

Specification

Model SCSJ-II SCSJ-III

Flow procedure PF+AC+RO+DI PF+AC+RO+DI

●Buffer disposing ●Physical and chemical


analysis

●Fine chemistry industry ●GC/HPLC


Application

●Inlet water for Ultra pure water machine

●Aseptic drinking water

Tap water:
TDS<200ppm,5-45°C,1.0-4.0Kgf/cm2
Feed water requirement
(if inlet TDS>200ppm,extra pretreatment is
recommended)

Special spun fiber filter×1+Special active


Pretreatment
carbon block filter×1+Special active carbon
unit
Purification block filter×1
system
100GPD RO 100GPD RO
RO unit
membrane×1 membrane×2
Subsequent Mixed bed resin Mixed bed resin
unit cartridge×2 cartridge×3

Desalination
Nearly 100*
rate%
Pure water
quality TDS RO water:5-10 ppm*

Resistivity 15-18.2MΩ.cm

Conductivity 0.067-0.055μs/cm

15 liters/hour* 30 liters/hour*

2 Liters/min(with pressure tank)

RO water, deionized water


Output(25°C)
Automatic electronic pressure sensor
controlling, RO membrane auto flushing,
automatic stop without water, automatic stop
when water tank full, automatic cutting off
water when pump stopping, guaranteeing 24
hours' work.

Flow rate TDS test pen +on-line resistivity monitor

Pure water outlet AC110-220V,50/60Hz, 48W plus model:72W

Control system L×W×H:41×22×42cm/12-14kg

Main body(including:1 set cartridge)+4.0


Standard configuration
gallon water tank+TDS pen+accessory box

You might also like